C8051F020DK Silicon Laboratories Inc, C8051F020DK Datasheet - Page 130

• Manufacturer Part Number: C8051F020DK
• Description: DEV KIT FOR F020/F021/F022/F023
• Manufacturer: Silicon Laboratories Inc
• Type: MCUr

Specifications of C8051F020DK

• Contents: Evaluation Board, Power Supply, USB Cables, Adapter and Documentation
• Processor To Be Evaluated: C8051F02x
• Interface Type: USB
• Silicon Manufacturer: Silicon Labs
• Core Architecture: 8051
• Silicon Core Number: C8051F020
• Silicon Family Name: C8051F02x
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: Silicon Laboratories C8051 F020/021/022/023
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 336-1200

C8051F020/1/2/3
13.8.1. Enable/Reset WDT
The watchdog timer is both enabled and reset by writing 0xA5 to the WDTCN register. The user's application soft-
ware should include periodic writes of 0xA5 to WDTCN as needed to prevent a watchdog timer overflow. The WDT
is enabled and reset as a result of any system reset.
13.8.2. Disable WDT
Writing 0xDE followed by 0xAD to the WDTCN register disables the WDT. The following code segment illustrates
disabling the WDT:
The writes of 0xDE and 0xAD must occur within 4 clock cycles of each other, or the disable operation is ignored.
Interrupts should be disabled during this procedure to avoid delay between the two writes.
13.8.3. Disable WDT Lockout
Writing 0xFF to WDTCN locks out the disable feature. Once locked out, the disable operation is ignored until the
next system reset. Writing 0xFF does not enable or reset the watchdog timer. Applications always intending to use the
watchdog should write 0xFF to WDTCN in the initialization code.
13.8.4. Setting WDT Interval
WDTCN.[2:0] control the watchdog timeout interval. The interval is given by the following equation:
For a 2 MHz system clock, this provides an interval range of 0.032 ms to 524 ms. WDTCN.7 must be logic 0 when
setting this interval. Reading WDTCN returns the programmed interval. WDTCN.[2:0] reads 111b after a system
reset.
130
4
3
CLR
MOV
MOV
SETB
+
WDTCN 2 0
EA
WDTCN,#0DEh
WDTCN,#0ADh
EA

–


T
sysclk
; disable all interrupts
; disable software watchdog timer
; re-enable interrupts
; where T
sysclk
is the system clock period.
Rev. 1.4