HD64F3337YCP16 Renesas Electronics America, HD64F3337YCP16 Datasheet - Page 567

• Manufacturer Part Number: HD64F3337YCP16
• Description: IC H8 MCU FLASH 60K 84PLCC
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300r

Specifications of HD64F3337YCP16

• Core Processor: H8/300
• Core Size: 8-Bit
• Speed: 16MHz
• Connectivity: Host Interface, I²C, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 74
• Program Memory Size: 60KB (60K x 8)
• Program Memory Type: FLASH
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 84-PLCC
• Package: 84PLCC
• Family Name: H8
• Maximum Speed: 16 MHz
• Operating Supply Voltage: 5 V
• Data Bus Width: 8 Bit
• Number Of Programmable I/os: 74
• Interface Type: HIF/I2C/SCI
• On-chip Adc: 8-chx10-bit
• On-chip Dac: 2-chx8-bit
• Number Of Timers: 3
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Writer Mode Transition Time: Commands cannot be accepted during the oscillation settling
period or the writer mode setup period. After the writer mode setup time, a transition is made to
memory read mode.
Table 21.21
Item
Standby release (oscillation settling time)
Writer mode setup time
V
Cautions on Memory Programming
1. When programming addresses which have previously been programmed, carry out auto-
2. When performing programming using writer mode on a chip that has been programmed/erased
Notes: 1. The flash memory is initially in the erased state when the device is shipped by Hitachi.
CC
erasing before auto-programming.
in an on-board programming mode, auto-erasing is recommended before carrying out auto-
programming.
hold time
RES
V
CC
2. Auto-programming should be performed once only on the same address block.
For other chips for which the erasure history is unknown, it is recommended that auto-
erasing be executed to check and supplement the initialization (erase) level.
Figure 21.23 Oscillation Settling Time, Boot Program Transfer Time,
Stipulated Transition Times to Command Wait State
t
osc1
t
bmv
and Power-Down Sequence
Memory
read mode
Command
wait state
Command acceptance
Symbol
t
t
t
osc1
bmv
dwn
Auto-program mode
Auto-erase mode
Min
10
10
0
Max
Command
wait state
Normal/
abnormal
end
identification
Unit
ms
ms
ms
t
dwn
Notes
535