TMPA901CMXBG Toshiba, TMPA901CMXBG Datasheet - Page 445

• Manufacturer Part Number: TMPA901CMXBG
• Description: Microcontrollers (MCU) 32-bit RISC MCU 16kb ARM926EJ 16kb 200Mhz
• Manufacturer: Toshiba

Specifications of TMPA901CMXBG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): -
• Rom Type: ROMless
• Ram (kbytes): 32
• Number Of Pins: 177
• Package: BGA
• Vcc: 3V
• Tft Lcd Controller: Y
• Touchscreen Controller: Y
• Usb Host Fs With Phy: Y
• Usb Device Hs With Phy: Y
• Sd Host Controller: -
• Cmos Image Sensor Interface: -
• I2s: 1
• Ssp (ch) Spi: 1
• I2mc/sio (ch): 1
• Uart/sio (ch): 2
• External Bus Interface: Y
• Cs/wait Controller (ch): 4
• Dma Controller: 8
• 10-bit Ad Converter: 4
• 12-bit Da Converter: -
• 16-bit Timer / Counter: 6
• Real Time Clock: Y
• Watchdog Timer: Y
• Osc Freq Detect: Y
• Low-power Modes: Y
• Lead Free Status / Rohs Status: Details

l.
m. <int_suspend_resume>
n. <int_nak>
o. <int_ep>
p. <int_ep0>
q. <int_sof>
r.
s.
t.
u. <int_setup>
<int_usb_reset>
Indicates whether UDC2 has asserted the usb_reset signal. The status of the usb_reset
signal can be checked using the usb_reset bit of Power Detect Control register.
0y0: UDC2 has not asserted the usb_reset signal after this bit was cleared.
0y1: Indicates UDC2 has asserted the usb_reset signal.
Asserts 1 each time the suspend_x signal of UDC2 changes. The status can be checked
using the suspend_x bit of Power Detect Control register.
0y0: Status has not changed
0y1: Status has changed
The int_nak signal of UDC2 can be directly read. To clear it, clear the corresponding bit of
INT or INT_NAK register of UDC2.
The int_ep signal of UDC2 can be directly read. To clear it, clear the corresponding bit of
INT or INT_EP register of UDC2.
The int_ep0 signal of UDC2 can be directly read. To clear it, clear the corresponding bit of
INT register of UDC2.
The int_sof signal of UDC2 can be directly read. To clear it, clear the corresponding bit of
INT register of UDC2.
<int_rx_zero>
The int_rx_zero signal of UDC2 can be directly read. To clear it, clear the corresponding
bit of INT or INT_RX_ZERO register of UDC2.
<int_status>
The int_status signal of UDC2 can be directly read. To clear it, clear the corresponding bit
of INT register of UDC2.
<int_status_nak>
The int_status_nak signal of UDC2 can be directly read. To clear it, clear the
corresponding bit of INT register of UDC2.
The int_setup signal of UDC2 can be directly read. To clear it, clear the corresponding bit
of INT register of UDC2.
TMPA901CM- 444
TMPA901CM
2010-07-29