TMPA901CMXBG Toshiba, TMPA901CMXBG Datasheet - Page 553

• Manufacturer Part Number: TMPA901CMXBG
• Description: Microcontrollers (MCU) 32-bit RISC MCU 16kb ARM926EJ 16kb 200Mhz
• Manufacturer: Toshiba

Specifications of TMPA901CMXBG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): -
• Rom Type: ROMless
• Ram (kbytes): 32
• Number Of Pins: 177
• Package: BGA
• Vcc: 3V
• Tft Lcd Controller: Y
• Touchscreen Controller: Y
• Usb Host Fs With Phy: Y
• Usb Device Hs With Phy: Y
• Sd Host Controller: -
• Cmos Image Sensor Interface: -
• I2s: 1
• Ssp (ch) Spi: 1
• I2mc/sio (ch): 1
• Uart/sio (ch): 2
• External Bus Interface: Y
• Cs/wait Controller (ch): 4
• Dma Controller: 8
• 10-bit Ad Converter: 4
• 12-bit Da Converter: -
• 16-bit Timer / Counter: 6
• Real Time Clock: Y
• Watchdog Timer: Y
• Osc Freq Detect: Y
• Low-power Modes: Y
• Lead Free Status / Rohs Status: Details

bmRequestType
0y00000000
Default state:
Address state:
Configured state: Nothing is specified for the operation of devices by the USB 2.0
(d) Set Address request
STATUS-Stage has ended.
When wValue = 0
Keeps the default state. No register access to UDC2 is required.
When wValue ≠ 0
Set wValue to bits 6-0 (dev_adr) and 0y010 to bits 10-8 (Device_State) of Address-State
register. UDC2 will be put in the address state.
When wValue = 0
Set 0x00 to bits 6-0 (dev_adr) and 0y001 to bits 10-8 (Device_State) of Address-State
register. UDC2 will be put in the Default state.
When wValue ≠ 0
Set wValue to bits 6-0 (dev_adr) of Address-State register.
UDC2 will be set to the new device address.
For this request, make register accesses shown below within 2 ms after the
(The device address should not be changed before the Setup_Fin command is issued.)
To this request, device addresses are set.
SET_ADDRESS
bRequest
specification.
TMPA901CM- 552
Device Address
wValue
wIndex
Zero
wLength
Zero
TMPA901CM
2010-07-29
Data
None