DS26519GA2 Maxim Integrated, DS26519GA2 Datasheet - Page 193
DS26519GA2
Manufacturer Part Number
DS26519GA2
Description
Network Controller & Processor ICs
Manufacturer
Maxim Integrated
Datasheet
1.DS26519GA2.pdf
(310 pages)
Specifications of DS26519GA2
Part # Aliases
90-26519-0A2
- Current page: 193 of 310
- Download datasheet (3Mb)
Register Name:
Register Description:
Register Address:
Bit #
Name
Default
Note: All bits in this register are latched and can cause interrupts
Bit 5: Receive FIFO Overrun (ROVR). Set when the receive HDLC controller has terminated packet reception
because the FIFO buffer is full.
Bit 4: Receive HDLC Opening Byte Event (RHOBT). Set when the next byte available in the receive FIFO is the
first byte of a message.
Bit 3: Receive Packet End Event (RPE). Set when the HDLC controller detects either the finish of a valid
message (i.e., CRC check complete) or when the controller has experienced a message fault such as a CRC
checking error, or an overrun condition, or an abort has been seen. This is a latched bit and will be cleared when
read.
Bit 2: Receive Packet Start Event (RPS). Set when the HDLC controller detects an opening byte. This is a
latched bit and will be cleared when read.
Bit 1: Receive FIFO Above High Watermark Set Event (RHWMS). Set when the receive 64-byte FIFO crosses
the high watermark as defined by the Receive HDLC FIFO Control Register (RHFC). Rising edge detect of RHWM.
Bit 0: Receive FIFO Not Empty Set Event (RNES). Set when the receive FIFO has transitioned from “empty” to
“not empty” (at least one byte has been put into the FIFO). Rising edge detect of RNE.
—
7
0
RLS5
Receive Latched Status Register 5 (HDLC)
094h + (200h x (n - 1)) + (2000h x [(n - 1) / 8]): where n = 1 to 16
—
6
0
ROVR
5
0
RHOBT
193 of 310
4
0
.
RPE
3
0
DS26519 16-Port T1/E1/J1 Transceiver
RPS
2
0
RHWMS
1
0
RNES
0
0
Related parts for DS26519GA2
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
Ds26519 16-port T1/e1/j1 Transceiver
Manufacturer:
Maxim Integrated Products, Inc.
Datasheet:
Part Number:
Description:
power light source LUXEON® Collimator
Manufacturer:
LUMILEDS [Lumileds Lighting Company]
Datasheet:
Part Number:
Description:
Single +5V, fully integrated, 1.25Gbps laser diode driver.
Manufacturer:
Maxim Integrated Products
Datasheet:
Part Number:
Description:
Single +5V, fully integrated, 155Mbps laser diode driver.
Manufacturer:
Maxim Integrated Products
Datasheet:
Part Number:
Description:
MAX7528KCWPMaxim Integrated Products [CMOS Dual 8-Bit Buffered Multiplying DACs]
Manufacturer:
Maxim Integrated Products
Datasheet:
Part Number:
Description:
VRD11/VRD10, K8 Rev F 2/3/4-Phase PWM Controllers with Integrated Dual MOSFET Drivers
Manufacturer:
Maxim Integrated Products
Datasheet:
Part Number:
Description:
Highly Integrated Level 2 SMBus Battery Chargers
Manufacturer:
Maxim Integrated Products
Datasheet:
Part Number:
Description:
Current Monitor and Accumulator with Integrated Sense Resistor; ; Temperature Range: -40°C to +85°C
Manufacturer:
Maxim Integrated Products
Part Number:
Description:
TSSOP 14/A°/RS-485 Transceivers with Integrated 100O/120O Termination Resis
Manufacturer:
Maxim Integrated Products
Part Number:
Description:
TSSOP 14/A°/RS-485 Transceivers with Integrated 100O/120O Termination Resis
Manufacturer:
Maxim Integrated Products
Part Number:
Description:
QFN 16/A°/AC-DC and DC-DC Peak-Current-Mode Converters with Integrated Step
Manufacturer:
Maxim Integrated Products
Part Number:
Description:
TDFN/A/65V, 1A, 600KHZ, SYNCHRONOUS STEP-DOWN REGULATOR WITH INTEGRATED SWI
Manufacturer:
Maxim Integrated Products
Part Number:
Description:
Integrated Temperature Controller f
Manufacturer:
Maxim Integrated Products
Part Number:
Description:
SOT23-6/I°/45MHz to 650MHz, Integrated IF VCOs with Differential Output
Manufacturer:
Maxim Integrated Products