DF2357F20 Renesas Electronics America, DF2357F20 Datasheet - Page 230

• Manufacturer Part Number: DF2357F20
• Description: IC H8S MCU FLASH 5V 128K 128QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of DF2357F20

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 87
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 128-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

The number of transfers is specified as 16 bits in ETCR. ETCR is decremented by 1 each time a transfer is executed, and
when its value reaches H'0000, the DTE bit is cleared and transfer ends. If the DTIE bit is set to 1 at this time, an interrupt
request is sent to the CPU or DTC.
The maximum number of transfers, when H'0000 is set in ETCR, is 65,536.
Transfer requests (activation sources) consist of A/D converter conversion end interrupts, external requests, SCI
transmission data empty and reception data full interrupts, and TPU channel 0 to 5 compare match/input capture A
interrupts. External requests can be set for channel B only.
When the DMAC is used in single address mode, only channel B can be set.
Figure 7-6 shows an example of the setting procedure for idle mode.
Rev.6.00 Oct.28.2004 page 200 of 1016
REJ09B0138-0600H
and transfer destination
Set number of transfers
Set transfer source
Idle mode setting
Read DMABCRL
Set DMABCRH
Set DMABCRL
Set DMACR
addresses
Idle mode
Figure 7-6 Example of Idle Mode Setting Procedure
[1]
[2]
[3]
[4]
[5]
[6]
[1] Set each bit in DMABCRH.
[2] Set the transfer source address and transfer
[3] Set the number of transfers in ETCR.
[4] Set each bit in DMACR.
[5] Read the DTE bit in DMABCRL as 0.
[6] Set each bit in DMABCRL.
• Set the DTE bit to 1 to enable transfer.
• Clear the FAE bit to 0 to select short address
• Specify enabling or disabling of internal
destination address in MAR and IOAR.
• Set the transfer data size with the DTSZ bit.
• Specify whether MAR is to be incremented or
• Set the RPE bit to 1.
• Specify the transfer direction with the DTDIR
• Select the activation source with bits DTF3 to
• Set the DTIE bit to 1.
mode.
decremented with the DTID bit.
DTF0.
interrupt clearing with the DTA bit.
bit.