MT29F4G08ABADAWP:D Micron Technology Inc, MT29F4G08ABADAWP:D Datasheet - Page 105

• Manufacturer Part Number: MT29F4G08ABADAWP:D
• Description: MICMT29F4G08ABADAWP:D 4GB SLC NAND 34NM
• Manufacturer: Micron Technology Inc

Specifications of MT29F4G08ABADAWP:D

• Lead Free Status / Rohs Status: Supplier Unconfirmed

Interleaved Die (Multi-LUN) Operations
PDF: 09005aef83b25735
m60a_4gb_nand.pdf – Rev. G 11/10 EN
In devices that have more than one die (LUN) per target, it is possible to improve per-
formance by interleaving operations between the die (LUNs). An interleaved die (multi-
LUN) operation is one that is issued to an idle die (LUN) (RDY = 1) while another die
(LUN) is busy (RDY = 0).
Interleaved die (multi-LUN) operations are prohibited following RESET (FFh), identifi-
cation (90h, ECh, EDh), and configuration (EEh, EFh) operations until ARDY =1 for all of
the die (LUNs) on the target.
During an interleaved die (multi-LUN) operation, there are two methods to determine
operation completion. The R/B# signal indicates when all of the die (LUNs) have finish-
ed their operations. R/B# remains LOW while any die (LUN) is busy. When R/B# goes
HIGH, all of the die (LUNs) are idle and the operations are complete. Alternatively, the
READ STATUS ENHANCED (78h) command can report the status of each die (LUN) in-
dividually.
If a die (LUN) is performing a cache operation, like PROGRAM PAGE CACHE (80h-15h),
then the die (LUN) is able to accept the data for another cache operation when status
register bit 6 is 1. All operations, including cache operations, are complete on a die
when status register bit 5 is 1.
During and following interleaved die (multi-LUN) operations, the READ STATUS (70h)
command is prohibited. Instead, use the READ STATUS ENHANCED (78h) command
to monitor status. This command selects which die (LUN) will report status. When two-
plane commands are used with interleaved die (multi-LUN) operations, the two-plane
commands must also meet the requirements in Two-Plane Operations.
See Command Definitions for the list of commands that can be issued while other die
(LUNs) are busy.
During an interleaved die (multi-LUN) operation that involves a PROGRAM series
(80h-10h, 80h-15h) operation and a READ operation, the PROGRAM series operation
must be issued before the READ series operation. The data from the READ series opera-
tion must be output to the host before the next PROGRAM series operation is issued.
This is because the 80h command clears the cache register contents of all cache regis-
ters on all planes.
105
Interleaved Die (Multi-LUN) Operations
4Gb, 8Gb: x8, x16 NAND Flash Memory
Micron Technology, Inc. reserves the right to change products or specifications without notice.
© 2009 Micron Technology, Inc. All rights reserved.