C8051F060DK Silicon Laboratories Inc, C8051F060DK Datasheet - Page 300

• Manufacturer Part Number: C8051F060DK
• Description: DEV KIT FOR F060/F062/F063
• Manufacturer: Silicon Laboratories Inc
• Type: MCUr

Specifications of C8051F060DK

• Contents: Evaluation Board, Power Supply, USB Cables, Adapter and Documentation
• Processor To Be Evaluated: C8051F06x
• Interface Type: USB
• Silicon Manufacturer: Silicon Labs
• Core Architecture: 8051
• Silicon Core Number: C8051F060
• Silicon Family Name: C8051F06x
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: C8051060, C8051F062 and C8051F063
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 336-1214

C8051F060/1/2/3/4/5/6/7
300
Bit7-5:
Bit4-3:
Bit2:
Bit1:
Bit0:
SFR Address: TMR2CF: 0xC9; TMR3CF: 0xC9; TMR4CF: 0xC9
SFR Page TMR2CF: page 0; TMR3CF: page 1; TMR4CF: page 2
Bit7
-
Reserved.
TnM1 and TnM0: Timer Clock Mode Select Bits.
Bits used to select the Timer clock source. The sources can be the System Clock
(SYSCLK), SYSCLK divided by 2 or 12, or an external clock signal routed to Tn (port pin)
divided by 8. Clock source is selected as follows:
00: SYSCLK/12
01: SYSCLK
10: EXTERNAL CLOCK/8
11: SYSCLK/2
TOGn: Toggle output state bit.
When timer is used to toggle a port pin, this bit can be used to read the state of the output, or
can be written to in order to force the state of the output.
TnOE: Timer output enable bit.
This bit enables the timer to output a 50% duty cycle output to the timer’s assigned external
port pin.
NOTE: A timer is configured for Square Wave Output as follows:
CP/RLn = 0
C/Tn
TnOE = 1
Load RCAPnH:RCAPnL (See “Toggle Mode Square Wave Frequency” on page 298.)
Configure Port Pin to output squarewave (See
0: Output of toggle mode not available at Timers’s assigned port pin.
1: Output of toggle mode available at Timers’s assigned port pin.
DCENn: Decrement Enable Bit.
This bit enables the timer to count up or down as determined by the state of TnEX.
0: Timer will count up, regardless of the state of TnEX.
1: Timer will count up or down depending on the state of TnEX as follows:
Bit6
Figure 24.14. TMRnCF: Timer 2, 3, and 4 Configuration Registers
-
= 0
if TnEX = 0, the timer counts DOWN
if TnEX = 1, the timer counts UP.
Bit5
-
TnM1
R/W
Bit4
Rev. 1.2
TnM0
R/W
Bit3
Section “18. Port Input/Output” on page
TOGn
R/W
Bit2
TnOE
R/W
Bit1
DCENn
R/W
Bit0
Reset Value
00000000
203)