DF2398F20V Renesas Electronics America, DF2398F20V Datasheet - Page 535

• Manufacturer Part Number: DF2398F20V
• Description: IC H8S/2300 MCU FLASH 128QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of DF2398F20V

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 87
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 128-QFP
• For Use With: YR0K42378FC000BA - KIT EVAL FOR H8S/2378
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

14.3.4
In clocked synchronous mode, data is transmitted or received in synchronization with clock pulses, making it suitable for
high-speed serial communication.
Inside the SCI, the transmitter and receiver are independent units, enabling full-duplex communication by use of a
common clock. Both the transmitter and the receiver also have a double-buffered structure, so that data can be read or
written during transmission or reception, enabling continuous data transfer.
Figure 14-14 shows the general format for clocked synchronous serial communication.
In clocked synchronous serial communication, data on the transmission line is output from one falling edge of the serial
clock to the next. Data confirmation is guaranteed at the rising edge of the serial clock.
In clocked serial communication, one character consists of data output starting with the LSB and ending with the MSB.
After the MSB is output, the transmission line holds the MSB state.
In clocked synchronous mode, the SCI receives data in synchronization with the rising edge of the serial clock.
Data Transfer Format: A fixed 8-bit data format is used.
No parity or multiprocessor bits are added.
Clock: Either an internal clock generated by the on-chip baud rate generator or an external serial clock input at the SCK
pin can be selected, according to the setting of the C/A bit in SMR and the CKE1 and CKE0 bits in SCR. For details of
SCI clock source selection, see table 14-9.
When the SCI is operated on an internal clock, the serial clock is output from the SCK pin.
Eight serial clock pulses are output in the transfer of one character, and when no transfer is performed the clock is fixed
high. When only receive operations are performed, however, the serial clock is output until an overrun error occurs or the
RE bit is cleared to 0. If you want to perform receive operations in units of one character, you should select an external
clock as the clock source.
Operation in Clocked Synchronous Mode
Note: * High except in continuous transfer
Serial
Serial
clock
data
Don’t care
Figure 14-14 Data Format in Synchronous Communication
*
LSB
Bit 0
Bit 1
One unit of transfer data (character or frame)
Bit 2
Bit 3
Bit 4
Bit 5
Rev.6.00 Oct.28.2004 page 505 of 1016
Bit 6
MSB
Bit 7
Don’t care
*
REJ09B0138-0600H