DF2398F20V Renesas Electronics America, DF2398F20V Datasheet - Page 664

• Manufacturer Part Number: DF2398F20V
• Description: IC H8S/2300 MCU FLASH 128QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of DF2398F20V

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 87
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 128-QFP
• For Use With: YR0K42378FC000BA - KIT EVAL FOR H8S/2378
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Rev.6.00 Oct.28.2004 page 634 of 1016
REJ09B0138-0600H
Note: If a memory cell does not operate normally and cannot be erased, one H'FF byte is
continuously at prescribed bit rate
host to indicate end of adjustment
of H'00 data transmitted by host
Host confirms normal reception
transmits one H'00 data byte to
indication (H'00), and transmits
After bit rate adjustment, chip
sets value in bit rate register
Chip calculates bit rate and
Chip measures low period
of bit rate adjustment end
Host transfers data (H'00)
chip transmits one H'AA
and execute reset-start
Set pins to boot mode
transmitted as an erase error, and the erase operation and subsequent operations
are halted.
After receiving H'55,
one H'55 data byte
data byte to host
Start
Figure 19-44 Boot Mode Execution Procedure
Host transmits programming control
program transferred to on-chip RAM
program sequentially in byte units
number of bytes to host as verify
of programming control program
programming control program to
control program to on-chip RAM
if data has already been written,
Transfer received programming
memory data has been erased,
host as verify data (echo-back)
Check flash memory data, and
bytes (N), upper byte followed
Execute programming control
chip transmits one H'AA data
After confirming that all flash
Host transmits number
Chip transmits received
Chip transmits received
End of transmission
data (echo-back)
erase all blocks
by lower byte
byte to host
n = N?
n = 1
Yes
No
n + 1
n