HD64F2636UF20 Renesas Electronics America, HD64F2636UF20 Datasheet - Page 523

• Manufacturer Part Number: HD64F2636UF20
• Description: IC H8S MCU FLASH 128K 128QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2600r

Specifications of HD64F2636UF20

• Core Processor: H8S/2600
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: CAN, SCI, SmartCard
• Peripherals: Motor Control PWM, POR, PWM, WDT
• Number Of I /o: 72
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 12x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 128-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

H8S/2639, H8S/2638, H8S/2636,
H8S/2630, H8S/2635 Group
13.3
13.3.1
The SCI can carry out serial communication in two modes: asynchronous mode in which
synchronization is achieved character by character, and clocked synchronous mode in which
synchronization is achieved with clock pulses.
Selection of asynchronous or clocked synchronous mode and the transmission format is made
using SMR as shown in table 13-8. The SCI clock is determined by a combination of the C/A bit
in SMR and the CKE1 and CKE0 bits in SCR, as shown in table 13-9.
Asynchronous Mode
• Data length: Choice of 7 or 8 bits
• Choice of parity addition, multiprocessor bit addition, and addition of 1 or 2 stop bits (the
• Detection of framing, parity, and overrun errors, and breaks, during reception
• Choice of internal or external clock as SCI clock source
Clocked Synchronous Mode
• Transfer format: Fixed 8-bit data
• Detection of overrun errors during reception
• Choice of internal or external clock as SCI clock source
REJ09B0103-0800 Rev. 8.00
May 28, 2010
combination of these parameters determines the transfer format and character length)
⎯ When internal clock is selected:
⎯ When external clock is selected:
⎯ When internal clock is selected:
⎯ When external clock is selected:
The SCI operates on the baud rate generator clock and a clock with the same frequency as
the bit rate can be output
A clock with a frequency of 16 times the bit rate must be input (the on-chip baud rate
generator is not used)
The SCI operates on the baud rate generator clock and a serial clock is output off-chip
The on-chip baud rate generator is not used, and the SCI operates on the input serial clock
Operation
Overview
Section 13 Serial Communication Interface (SCI)
Page 473 of 1458