FDC37B727-NS Standard Microsystems (SMSC), FDC37B727-NS Datasheet - Page 155

• Manufacturer Part Number: FDC37B727-NS
• Manufacturer: Standard Microsystems (SMSC)

Specifications of FDC37B727-NS

• Pin Count: 128
• Lead Free Status / RoHS Status: Compliant

Either Edge Triggered Interrupts
Four GPIO pins are implemented that allow an
interrupt to be generated on both a high-to-low
and a low-to-high edge transition, instead of one
or the other as selected by the polarity bit.
The either edge triggered interrupts function as
follows: Selecting the Either Edge Triggered
Interrupt (EETI) function for these GPIO pins is
applicable when the combined interrupt is
enabled for the GPIO pin (GPINT1 for GP11 and
GP12, and GPINT2 for GP53 and GP54).
Otherwise, selection of the EETI function will
produce no function for the pin.
Miscellaneous Status Register
The MSC_STS register is implemented as follows to hold the status bits of these four GPIOs.
Miscellaneous Status Register (PM1_STS)
Register Location:
Default Value:
Attribute:
Size:
0
1
2
3
4
5-7
BIT
EETI1_STS
EETI2_STS
EETI3_STS
EETI4_STS
VTRPOR_STS
Reserved
NAME
<PM1_BLK>+16h System I/O Space
00h on Vbat POR
Read/Write (Note 0)
8-bits
Either Edge Triggered Interrupt Input 1 Status. This bit is set when
an edge occurs on the GP11 pin. This bit is cleared by writing a 1 to
this bit position (writing a 0 has no effect).
Either Edge Triggered Interrupt Input 2 Status. This bit is set when
an edge occurs on the GP12 pin. This bit is cleared by writing a 1 to
this bit position (writing a 0 has no effect).
Either Edge Triggered Interrupt Input 3 Status. This bit is set when
an edge occurs on the GP53 pin. This bit is cleared by writing a 1 to
this bit position (writing a 0 has no effect).
Either Edge Triggered Interrupt Input 4 Status. This bit is set when
an edge occurs on the GP54 pin. This bit is cleared by writing a 1 to
this bit position (writing a 0 has no effect).
This bit is set upon VTR POR. This bit is cleared by writing a 1 to
this bit position (writing a 0 has no effect). Additionally, when the
system turns on (nPowerOn active low) due to a VTR POR, then an
SCI is generated.
Reserved. This bit always returns zero.
If the EETI
155
function is selected for the GPIO pin, then the
bits that control input/output, polarity and open
collector/push-pull have no effect on the function
of the pin. However, the polarity bit does affect
the value of the GP bit (i.e., register GP1, bit 2
for GP12).
An interrupt occurs if the status bit is set and the
interrupt is enabled.
which of the EETI interrupts transitioned. These
status bits are located in the MSC_STS register.
The status is valid whether or not the interrupt is
enabled and whether or not the EETI function is
selected for the pin.
DEFINITION
The status bits indicate