HD6412320 RENESAS [Renesas Technology Corp], HD6412320 Datasheet - Page 332

• Manufacturer Part Number: HD6412320
• Description: Renesas 16-Bit Single-Chip Microcomputer H8S Family H8S-2300 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

Section 7 DMA Controller (Not Supported in the H8S/2321)
7.5.16
If the DTE bit for the channel currently operating is cleared to 0, the DMAC stops on completion
of the 1-byte or 1-word transfer in progress. DMAC operation resumes when the DTE bit is set to
1 again.
In full address mode, the same applies to the DTME bit.
Figure 7.37 shows the procedure for forcibly terminating DMAC operation by software.
Rev.6.00 Sep. 27, 2007 Page 302 of 1268
REJ09B0220-0600
Figure 7.37 Example of Procedure for Forcibly Terminating DMAC Operation
Forced termination
Forced termination
Clear DTE bit to 0
Forced Termination of DMAC Operation
of DMAC
[1]
[1] Clear the DTE bit in DMABCRL to 0.
To prevent interrupt generation after forced
termination of DMAC operation, clear the DTIE bit
to 0 at the same time.