r5s77631ay266bgv Renesas Electronics Corporation., r5s77631ay266bgv Datasheet - Page 1158

• Manufacturer Part Number: r5s77631ay266bgv
• Description: Renesas 32-bit Risc Microcomputer Superhtm Risc Engine Family Sh-4a Series
• Manufacturer: Renesas Electronics Corporation.

Section 27 Serial Communication Interface with FIFO (SCIF)
27.4
27.4.1
The SCIF can carry out serial communication in asynchronous mode, in which synchronization is
achieved character by character and in synchronous mode, in which synchronization is achieved
with clock pulses. For details on asynchronous mode, see section 27.4.2, Operation in
Asynchronous Mode.
64-stage FIFO buffers are provided for both transmission and reception, reducing the CPU
overhead, and enabling fast and continuous communication to be performed.
SCIF_RTS and SCIF_CTS signals are also provided as modem control signals (channel 0 only).
The serial transfer format is selected using SCSMR, as shown in table 27.5. The SCIF clock
source is determined by the combination of the C/A bit in SCSMR and the CKE1 and CKE0 bits
in SCSCR, as shown in table 27.6.
Asynchronous Mode:
• Data length: Choice of 7 or 8 bits
• Choice of parity addition and addition of 1 or 2 stop bits (the combination of these parameters
• Detection of framing errors, parity errors, receive-FIFO-data-full state, overrun errors, receive-
• Indication of the number of data bytes stored in the transmit and receive FIFO registers
• Choice of internal or external clock as SCIF clock source
Clocked Synchronous Mode:
• Data length: Fixed at 8 bits
• Detection of overrun errors during reception
• Choice of internal or external clock as SCIF clock source
Rev. 1.00 Oct. 01, 2007 Page 1092 of 1956
REJ09B0256-0100
determines the transfer format and character length)
data-ready state, and breaks, during reception
When internal clock is selected: The SCIF operates on the baud rate generator clock and can
output a clock with frequency of 16 times the bit rate.
When external clock is selected: A clock with a frequency of 16 times the bit rate must be
input (the on-chip baud rate generator is not used).
When internal clock is selected: The SCIF operates on the baud rate generator clock and a
Operation
Overview
serial clock is output to external devices.