DF2328BVF25V Renesas Electronics America, DF2328BVF25V Datasheet - Page 277

• Manufacturer Part Number: DF2328BVF25V
• Description: IC H8S MCU FLASH 256K 128QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of DF2328BVF25V

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 25MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 87
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 128-QFP
• For Use With: EDK2329 - DEV EVALUATION KIT H8S/2329
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Other names: HD64F2328BVF25V

Bit 14—Full Address Enable 0 (FAE0): Specifies whether channel 0 is to be used in short
address mode or full address mode.
In full address mode, channels 0A and 0B are used together as a single channel.
Bit 14
FAE0
0
1
Bits 13 and 12—Reserved: Can be read or written to. Only 0 should be written to these bits.
Bits 11 and 9—Data Transfer Acknowledge (DTA): These bits enable or disable clearing, when
DMA transfer is performed, of the internal interrupt source selected by the data transfer factor
setting.
When DTE = 1 and DTA = 1, the internal interrupt source selected by the data transfer factor
setting is cleared automatically by DMA transfer. When DTE = 1 and DTA = 1, the internal
interrupt source selected by the data transfer factor setting does not issue an interrupt request to the
CPU or DTC.
When DTE = 1 and DTA = 0, the internal interrupt source selected by the data transfer factor
setting is not cleared when a transfer is performed, and can issue an interrupt request to the CPU
or DTC in parallel. In this case, the interrupt source should be cleared by the CPU or DTC
transfer.
When DTE = 0, the internal interrupt source selected by the data transfer factor setting issues an
interrupt request to the CPU or DTC regardless of the DTA bit setting.
The state of the DTME bit does not affect the above operations.
Bit 11—Data Transfer Acknowledge 1 (DTA1): Enables or disables clearing, when DMA
transfer is performed, of the internal interrupt source selected by the channel 1 data transfer factor
setting.
Bit 11
DTA1
0
1
Description
Short address mode
Full address mode
Description
Clearing of selected internal interrupt source at time of DMA transfer is disabled
Clearing of selected internal interrupt source at time of DMA transfer is enabled
Section 7 DMA Controller (Not Supported in the H8S/2321)
Rev.6.00 Sep. 27, 2007 Page 245 of 1268
REJ09B0220-0600
(Initial value)
(Initial value)