HD6417709SF133B Renesas Electronics America, HD6417709SF133B Datasheet - Page 346

• Manufacturer Part Number: HD6417709SF133B
• Description: IC SUPERH MPU ROMLESS 208LQFP
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7700r

Specifications of HD6417709SF133B

• Core Processor: SH-3
• Core Size: 32-Bit
• Speed: 133MHz
• Connectivity: EBI/EMI, FIFO, IrDA, SCI, SmartCard
• Peripherals: DMA, POR, WDT
• Number Of I /o: 96
• Program Memory Type: ROMless
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 1.65 V ~ 2.05 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 208-LQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Program Memory Size: -

Self-Refreshing
Self-refresh mode is a kind of standby mode in which the refresh timing and refresh addresses
are generated within the synchronous DRAM. Self-refreshing is activated by setting both the
RMODE bit and the RFSH bit to 1. The self-refresh state is maintained while the CKE signal
is low. Synchronous DRAM cannot be accessed while in the self-refresh state. Self-refresh
mode is cleared by clearing the RMODE bit to 0. After self-refresh mode has been cleared,
command issuance is disabled for the number of cycles specified by the TPC bits in MCR.
Self-refresh timing is shown in figure 10.27. Settings must be made so that self-refresh
clearing and data retention are performed correctly, and auto-refreshing is performed at the
correct intervals. When self-refreshing is activated from the state in which auto-refreshing is
set, or when exiting standby mode other than through a power-on reset, auto-refreshing is
restarted if RFSH is set to 1 and RMODE is cleared to 0 when self-refresh mode is cleared. If
the transition from clearing of self-refresh mode to the start of auto-refreshing takes time, this
time should be taken into consideration when setting the initial value of RTCNT. Making the
RTCNT value 1 less than the RTCOR value will enable refreshing to be started immediately.
After self-refreshing has been set, the self-refresh state continues even if the chip standby state
is entered using the SH7709S’s standby function, and is maintained even after recovery from
standby mode other than through a power-on reset. In case of a power-on reset, the bus state
controller’s registers are initialized, and therefore the self-refresh state is cleared.
Self-refreshing is performed in normal operation, in sleep mode, in standby mode, and in case
of a manual reset.
When using synchronous DRAM, use the following procedure to initiate self-refreshing.
1. Clear the refresh control bit to 0.
2. Write H'00 to the RTCNT register.
3. Set the refresh control bit and refresh mode bit to 1.
Rev. 5.00, 09/03, page 300 of 760