DS33Z41 Maxim Integrated Products, DS33Z41 Datasheet - Page 167

• Manufacturer Part Number: DS33Z41
• Description: Network Controller & Processor ICs Quad Inverse-Multipl exing Ethernet Mappe
• Manufacturer: Maxim Integrated Products

Specifications of DS33Z41

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

14 DOCUMENT REVISION HISTORY
Maxim/Dallas Semiconductor cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim/Dallas Semiconductor product.
No circuit patent licenses are implied. Maxim/Dallas Semiconductor reserves the right to change the circuitry and specifications without notice at any time.
M a x i m I n t e g r a t e d P r o d u c t s , 1 2 0 S a n G a b r i e l D r i v e , S u n n y v a l e , C A 9 4 0 8 6 4 0 8 - 7 3 7 - 7 6 0 0
REVISION
021405
122006
The Maxim logo is a registered trademark of Maxim Integrated Products, Inc. The Dallas logo is a registered trademark of Dallas Semiconductor.
New Product Release
Added TCLKI to TSER Output Delay Minimum of 3ns.
Added TCLKI to TSYNC Setup Time Minimum of 3.5ns.
Added definition for BPCLR.PLF[4:0].
Corrected pin description of MDC.
Corrected default value listed in the SU.RMFSRL register definition.
Added GL.SDMODE1, GL.SDMODE2, GL.SDMODEWS, and GL.SDRFTC register
definitions.
Added GL.SDMODE1, GL.SDMODE2, GL.SDMODEWS, and GL.SDRFTC registers to the
register bit map.
Clarified the GL.C1QPR register definition.
Corrected SU.MACCR.PM and SU.MACCR.PAM bit definitions.
Corrected pin description of RST.
Corrected pin description of REF_CLK.
Clarified text regarding use of REF_CLKO in DCE and RMII modes.
Corrected SU.GCR.H10S bit definition.
Corrected the SU.RQLT and SU.RQHT default values to zero.
Corrected SU.MACCR register definition.
Removed a reference to SPI and EEPROM mode.
Clarified section 8.19 on X.86 mode synchronization.
Corrected low-power mode information in section 8.4.
Added D/C operating current maximum values.
Updated D/C operating current typical values.
Added D/C Characteristic entries for Supply currents in “standby” conditions.
Corrected the link start command value in the GL.IMXC register definition.
Clarified RSER conditions for unused input time slots.
Updated package drawing.
© 2006 Maxim Integrated Products
167 of 167
DESCRIPTION
DS33Z41 Quad IMUX Ethernet Mapper