HD6412340 HITACHI [Hitachi Semiconductor], HD6412340 Datasheet - Page 424

• Manufacturer Part Number: HD6412340
• Description: H8S/2345 F-ZTAT Hardware Manual
• Manufacturer: HITACHI [Hitachi Semiconductor]

11.5.3
If the mode is switched from watchdog timer to interval timer, or vice versa, while the WDT is
operating, errors could occur in the incrementation. Software must stop the watchdog timer (by
clearing the TME bit to 0) before switching the mode.
11.5.4
If the WDTOVF output signal* is input to the RES pin of the H8S/2345 Series, the H8S/2345
Series will not be initialized correctly. Make sure that the WDTOVF signal* is not input logically
to the RES pin. To reset the entire system by means of the WDTOVF signal*, use the circuit
shown in figure 11.9.
Note: * The WDTOVF pin function is not supported by the F-ZTAT version.
11.5.5
The H8S/2345 Series is not reset internally if TCNT overflows while the RSTE bit is cleared to 0
during watchdog timer operation, but TCNT and TSCR of the WDT are reset.
TCNT, TCSR, and RSTCR cannot be written to while the WDTOVF signal* is low. Also note that
a read of the WOVF flag is not recognized during this period. To clear the WOVF flag, therefore,
read TCSR after the WDTOVF signal* goes high, then write 0 to the WOVF flag.
Note: * The WDTOVF pin function is not supported by the F-ZTAT version.
Note: * The WDTOVF pin function is not supported by the F-ZTAT version.
Switching between Watchdog Timer Mode and Interval Timer Mode
System Reset by WDTOVF Signal
Reset signal to entire system
Internal Reset in Watchdog Timer Mode
Figure 11.9 Circuit for System Reset by WDTOVF Signal (Example)
Reset input
WDTOVF *
RES
H8S/2345
409