HD64F3664H Renesas Electronics America, HD64F3664H Datasheet - Page 130

• Manufacturer Part Number: HD64F3664H
• Description: IC H8 MCU FLASH 32K 64QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300H Tinyr

Specifications of HD64F3664H

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 16MHz
• Connectivity: I²C, SCI
• Peripherals: PWM, WDT
• Number Of I /o: 29
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: FLASH
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 64-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Section 7 ROM
7.2.5
Bit 7 (FLSHE) in FENR enables or disables the CPU access to the flash memory control registers,
FLMCR1, FLMCR2, EBR1, and FLPWCR.
7.3
There are two modes for programming/erasing of the flash memory; boot mode, which enables on-
board programming/erasing, and programmer mode, in which programming/erasing is performed
with a PROM programmer. On-board programming/erasing can also be performed in user
program mode. At reset-start in reset mode, the series of HD64F3664 changes to a mode
depending on the TEST pin settings, NMI pin settings, and input level of each port, as shown in
table 7.1. The input level of each pin must be defined four states before the reset ends.
When changing to boot mode, the boot program built into this LSI is initiated. The boot program
transfers the programming control program from the externally-connected host to on-chip RAM
via SCI3. After erasing the entire flash memory, the programming control program is executed.
This can be used for programming initial values in the on-board state or for a forcible return when
programming/erasing can no longer be done in user program mode. In user program mode,
individual blocks can be erased and programmed by branching to the user program/erase control
program prepared by the user.
Table 7.1
[Legend]
X:
Rev. 6.00 Mar. 24, 2006 Page 100 of 412
REJ09B0142-0600
Bit
7
6 to 0
TEST
0
0
1
Don't care.
Flash Memory Enable Register (FENR)
On-Board Programming Modes
NMI
1
0
X
Bit
Name
FLSHE
—
Setting Programming Modes
P85
X
1
X
Initial
Value
0
All 0
X
0
PB0
X
R/W
R/W
—
PB1
X
X
0
Description
Flash Memory Control Register Enable
Flash memory control registers can be accessed when
this bit is set to 1. Flash memory control registers
cannot be accessed when this bit is set to 0.
Reserved
These bits are always read as 0.
PB2
X
X
0
User Mode
Boot Mode
Programmer Mode
LSI State after Reset End