ATMEGA16HVA-4CKU Atmel, ATMEGA16HVA-4CKU Datasheet - Page 123

• Manufacturer Part Number: ATMEGA16HVA-4CKU
• Description: MCU AVR 16K FLASH 4MHZ 36-LGA
• Manufacturer: Atmel
• Series: AVR® ATmegar

Specifications of ATMEGA16HVA-4CKU

• Core Processor: AVR
• Core Size: 8-Bit
• Speed: 4MHz
• Connectivity: SPI
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Number Of I /o: 7
• Program Memory Size: 16KB (8K x 16)
• Program Memory Type: FLASH
• Eeprom Size: 256 x 8
• Ram Size: 512 x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 9 V
• Data Converters: A/D 5x12b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 85°C
• Package / Case: 36-LGA
• Processor Series: ATMEGA16x
• Core: AVR8
• Data Bus Width: 8 bit
• Data Ram Size: 512 B
• Interface Type: SPI
• Maximum Clock Frequency: 4 MHz
• Number Of Programmable I/os: 6
• Number Of Timers: 2
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• 3rd Party Development Tools: EWAVR, EWAVR-BL
• Development Tools By Supplier: ATAVRDRAGON, ATSTK500, ATSTK600, ATAVRISP2, ATAVRONEKIT, ATAVRSB200, ATAVRSB201
• Minimum Operating Temperature: - 20 C
• On-chip Adc: 12 bit, 5 Channel
• For Use With: ATSTK600 - DEV KIT FOR AVR/AVR32ATSTK500 - PROGRAMMER AVR STARTER KIT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

22.3
22.4
22.4.1
8024A–AVR–04/08
Voltage Regulator Monitor
Register Description
ROCR – Regulator Operating Condition Register
This module monitors the operating state of the Voltage Regulator. If the voltage at VFET drops
below the Regulator Short-circuit Level (RSCL), see
Voltage Regulator enters the Battery Pack Short mode. In this mode, VFET is disconnected from
VREG to avoid a quick drop in the voltage regulator output. When the voltage regulator enters
this mode, the chip will be completely powered by the external reservoir capacitor (CREG). This
allows the chip to operate a certain time without entering BOD reset, even if the VFET voltage is
too low for the voltage regulator to operate.
An interrupt is issued when the regulator enters Battery Pack Short mode, if the ROCWIE bit in
ROCR Register is set. This allows actions to be taken to reduce power consumption and hence
prolonging the time that CREG can be used to power the chip. In a typical short-circuit situation,
VFET will drop as a consequence of high current consumption, and recover as soon as the Bat-
tery Protection module has disabled the FETs. Hence CREG should be dimensioned so that the
chip can sustain operation without entering BOD reset, until the FETs are disabled either by HW
or SW. To minimize power consumption when the Voltage Regulator enters the Battery Pack
Short mode, the chip should enter Power-save sleep mode as soon as possible after the ROC-
WIF interrupt is detected. The Watchdog Timer should be configured to wake up the CPU after a
time that is considered safe, see appnote AVR132 for use of enhanced Watchdog Timer. Soft-
ware should then check the status of the ROC flag. If the ROCS flag is cleared, normal operation
may be resumed.
• Bit 7 – ROCS: ROC Status
This bit is set when the Voltage Regulator operates in the Battery Pack Short mode, and cleared
otherwise.
• Bit 6:2 – Res: Reserved Bits
These bits are reserved bits and will always read as zero.
• Bit 1 – ROCWIF: ROC Warning Interrupt Flag
The ROCWIF Flag is set within the ROCW reaction time when the Voltage Regulator enters the
Battery Pack Short mode. The flag is cleared by writing a logic one to it or by hardware, by exe-
cuting the corresponding interrupt handling vector.
• Bit 0 – ROCWIE: ROC Warning Interrupt Enable
The ROCWIE bit enables interrupt caused by the Regulator Operating Condition Warning inter-
rupt flag.
Bit
(0xC8)
Read/Write
Initial Value
ROCS
R
7
0
R
6
0
-
R
5
0
-
R
4
0
-
R
0
3
-
”Electrical Characteristics” on page
ATmega8HVA/16HVA
R
2
0
-
ROCWIF
R/W
1
0
ROCWIE
R/W
0
0
ROCR
165, the
123