st7pmc2s6 STMicroelectronics, st7pmc2s6 Datasheet - Page 313

• Manufacturer Part Number: st7pmc2s6
• Description: 8-bit Mcu For Automotive With Nested Interrupts, Flash, 10-bit Adc, Brushless Motor Control, 5 Timers, Spi, Linsci?
• Manufacturer: STMicroelectronics

ST7MC1K2-Auto, ST7MC1K6-Auto, ST7MC2S4-Auto, ST7MC2S6-Auto
Figure 130. Pin input voltage
12.2
Stresses above those listed as “absolute maximum ratings” may cause permanent damage to the device.
This is a stress rating only and functional operation of the device under these conditions is not implied.
Exposure to maximum rating conditions for extended periods may affect device reliability.
12.2.1
Table 186. Voltage characteristics
1. Directly connecting the RESET and I/O pins to V
2. I
| V
generated or an unexpected change of the I/O configuration occurs (for example, due to a corrupted program counter). To
guarantee safe operation, this connection has to be done through a pull-up or pull-down resistor (typical: 4.7k for RESET,
10k for I/Os). For the same reason, unused I/O pins must not be directly tied to V
respected, the injection current must be limited externally to the I
while a negative injection is induced by V
INJ(PIN)
DDx
|V
V
V
V
V
SSA
Symbol
ESD(HBM)
DD
PP
ESD(MM)
| and | V
V
- V
- V
- V
must never be exceeded. This is implicitly insured if V
IN
SS
SS
SSx
Absolute maximum ratings
Voltage characteristics
|
SSx
| Variations between different digital power pins
Supply voltage
Programming voltage
Input voltage on any pin
Variations between digital and analog ground pins
Electro-static discharge voltage (Human body model)
Electro-static discharge voltage (Machine model)
IN
< V
SS
DD
(1)(2)
.
V
Ratings
IN
or V
SS
could damage the device if an unintentional internal reset is
IN
maximum is respected. If V
INJ(PIN)
ST7 PIN
value. A positive injection is induced by V
DD
or V
SS
See
maximum ratings (electrical
sensitivity) on page 327
IN
.
V
Electrical characteristics
Maximum value
maximum cannot be
SS
Section 12.7.3: Absolute
-0.3 to V
6.5
50
50
13
DD
+0.3
IN
> V
313/371
DD
Unit
mV
V