st7pmc2s6 STMicroelectronics, st7pmc2s6 Datasheet - Page 36

• Manufacturer Part Number: st7pmc2s6
• Description: 8-bit Mcu For Automotive With Nested Interrupts, Flash, 10-bit Adc, Brushless Motor Control, 5 Timers, Spi, Linsci?
• Manufacturer: STMicroelectronics

Flash program memory
4.6
4.7
4.8
36/371
IAP (in-application programming)
This mode uses a Bootloader program previously stored in Sector 0 by the user (in ICP
mode or by plugging the device in a programming tool).
This mode is fully controlled by user software. This allows it to be adapted to the user
application, (user-defined strategy for entering programming mode, choice of
communications protocol used to fetch the data to be stored, etc.). For example, it is
possible to download code from the SPI, SCI or other type of serial interface and program it
in the Flash. IAP mode can be used to program any of the Flash sectors except Sector 0,
which is write/erase protected to allow recovery in case errors occur during the
programming operation.
Related documentation
For details on Flash programming and ICC protocol, refer to the ST7 Flash Programming
Reference Manual and to the ST7 ICC Protocol Reference Manual
Flash control status register (FCSR)
This register is reserved for use by programming tool software. It controls the Flash
programming and erasing operations.
FCSR
7
6
ST7MC1K2-Auto, ST7MC1K6-Auto, ST7MC2S4-Auto, ST7MC2S6-Auto
5
4
R/W
0
3
2
Reset value: 0000 0000 (00h)
.
1
0