DF2367VF33 Renesas Electronics America, DF2367VF33 Datasheet - Page 781

• Manufacturer Part Number: DF2367VF33
• Description: MCU 3V 384K 128-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of DF2367VF33

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 33MHz
• Connectivity: I²C, IrDA, SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 84
• Program Memory Size: 384KB (384K x 8)
• Program Memory Type: FLASH
• Ram Size: 24K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 10x10b, D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 128-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Other names: HD64F2367VF33; HD64F2367VF33

20.1.2
The comparison table of programming and erasing related items about boot mode, user program
mode, user boot mode, and PROM mode is shown in table 20.1.
Table 20.1 Comparison of Programming Modes
Notes: 1. All-erasure is performed. After that, the specified block can be erased.
• The user boot MAT can be programmed or erased only in boot mode and PROM mode.
• The user MAT and user boot MAT are erased in boot mode. Then, the user MAT and user boot
• The boot operation of the optional interface can be performed by the mode pin setting different
Programming/
erasing
environment
Programming/
erasing enable
MAT
All erasure
Block division
erasure
Program data
transfer
Reset initiation
MAT
Transition to
user mode
MAT can be programmed by means of the command method. However, the contents of the
MAT cannot be read until this state.
Only user boot MAT is programmed and the user MAT is programmed in user boot mode or
only user MAT is programmed because user boot mode is not used.
from user program mode in user boot mode.
2. Firstly, the reset vector is fetched from the embedded program storage MAT. After the
Mode Comparison
flash memory related registers are checked, the reset vector is fetched from the user
boot MAT.
Boot mode
On-board
programming
User MAT
User boot MAT
From host via
SCI
Embedded
program storage
MAT
Changing mode
setting and reset
(Automatic)
*
1
User program
mode
On-board
programming
User MAT
From optional
device via RAM
User MAT
Changing FLSHE
bit
Section 20 Flash Memory (0.18-μm F-ZTAT Version)
Rev.6.00 Mar. 18, 2009 Page 721 of 980
User boot mode
On-board
programming
User MAT
From optional
device via RAM
User boot MAT *
Changing mode
setting and reset
2
REJ09B0050-0600
PROM mode
Off-board
programming
User MAT
User boot MAT
×
Via programmer
⎯
⎯
(Automatic)