MC68HC908MR16CFU Freescale Semiconductor, MC68HC908MR16CFU Datasheet - Page 63

• Manufacturer Part Number: MC68HC908MR16CFU
• Description: IC MCU 8MHZ 16K FLASH 64-QFP
• Manufacturer: Freescale Semiconductor
• Series: HC08r

Specifications of MC68HC908MR16CFU

• Core Processor: HC08
• Core Size: 8-Bit
• Speed: 8MHz
• Connectivity: SCI, SPI
• Peripherals: LVD, POR, PWM
• Number Of I /o: 44
• Program Memory Size: 16KB (16K x 8)
• Program Memory Type: FLASH
• Ram Size: 768 x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 10x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 64-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

two to correct the duty cycle. Therefore, the bus clock frequency, which is one-half of the base clock
frequency, is one-fourth the frequency of the selected clock (CGMXCLK or CGMVCLK).
The BCS bit in the PLL control register (PCTL) selects which clock drives CGMOUT. The VCO clock
cannot be selected as the base clock source if the PLL is not turned on. The PLL cannot be turned off if
the VCO clock is selected. The PLL cannot be turned on or off simultaneously with the selection or
deselection of the VCO clock. The VCO clock also cannot be selected as the base clock source if the
factor L is programmed to a 0. This value would set up a condition inconsistent with the operation of the
PLL, so that the PLL would be disabled and the crystal clock would be forced as the source of the base
clock.
4.3.4 CGM External Connections
In its typical configuration, the CGM requires seven external components. Five of these are for the crystal
oscillator and two are for the PLL.
The crystal oscillator is normally connected in a Pierce oscillator configuration, as shown in
Figure 4-3
circuitry.
The oscillator configuration uses five components:
The series resistor (R
be required for all ranges of operation, especially with high-frequency crystals. Refer to the crystal
manufacturer’s data for more information.
Freescale Semiconductor
1. Crystal, X
2. Fixed capacitor, C
3. Tuning capacitor, C
4. Feedback resistor, R
5. Series resistor, R
shows only the logical representation of the internal components and may not represent actual
1
SIMOSCEN
S
) is included in the diagram to follow strict Pierce oscillator guidelines and may not
S
1
OSC1
C1
(optional)
2
MC68HC908MR32 • MC68HC908MR16 Data Sheet, Rev. 6.1
B
(can also be a fixed capacitor)
R
X1
Figure 4-3. CGM External Connections
B
OSC2
R
C2
S
*
CGMXCLK
V
SS
*RS can be 0 (shorted) when used with
higher frequency crystals. Refer to
manufacturer’s data.
CGMXFC
C
F
V
C
DDA
BYP
Functional Description
V
DD
Figure
4-3.
63