PPC8567EVTAUJJ Freescale Semiconductor, PPC8567EVTAUJJ Datasheet - Page 64

• Manufacturer Part Number: PPC8567EVTAUJJ
• Description: MCU PWRQUICC III 1023-FCPBGA
• Manufacturer: Freescale Semiconductor

Specifications of PPC8567EVTAUJJ

• Processor Type: MPC85xx PowerQUICC III 32-Bit
• Speed: 1.333GHz
• Voltage: 1.1V
• Mounting Type: Surface Mount
• Package / Case: 1023-BBGA, FCBGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -

High-Speed Serial Interfaces (HSSI)
13.2.2
The DC level requirement for the MPC8568E SerDes reference clock inputs is different depending on the
signaling mode used to connect the clock driver chip and SerDes reference clock inputs as described
below.
64
•
•
Differential Mode
— The input amplitude of the differential clock must be between 400mV and 1600mV differential
— For external DC-coupled connection, as described in section 13.2.1, the maximum average
— For external AC-coupled connection, there is no common mode voltage requirement for the
Single-ended Mode
— The reference clock can also be single-ended. The SD_REF_CLK input amplitude
— The SD_REF_CLK input average voltage must be between 200 and 400 mV.
— To meet the input amplitude requirement, the reference clock inputs might need to be DC or
peak-peak (or between 200mV and 800mV differential peak). In other words, each signal wire
of the differential pair must have a single-ended swing less than 800mV and greater than
200mV. This requirement is the same for both external DC-coupled or AC-coupled connection.
current requirements sets the requirement for average voltage (common mode voltage) to be
between 100 mV and 400 mV.
for DC-coupled connection scheme.
clock driver. Since the external AC-coupling capacitor blocks the DC level, the clock driver
and the SerDes reference clock receiver operate in different command mode voltages. The
SerDes reference clock receiver in this connection scheme has its common mode voltage set to
SCOREGND. Each signal wire of the differential inputs is allowed to swing below and above
the command mode voltage (SCOREGND).
requirement for AC-coupled connection scheme.
(single-ended swing) must be between 400mV and 800mV peak-peak (from Vmin to Vmax)
with SD_REF_CLK either left unconnected or tied to ground.
the SerDes reference clock input requirement for single-ended signaling mode.
AC-coupled externally. For the best noise performance, the reference of the clock could be DC
MPC8568E/MPC8567E PowerQUICC III Integrated Processor Hardware Specifications, Rev. 1
DC Level Requirement for SerDes Reference Clocks
SD_REF_CLK
SD_REF_CLK
Figure 40. Receiver of SerDes Reference Clocks
Figure 41
50 Ω
50 Ω
shows the SerDes reference clock input requirement
Figure 42
Input
Amp
shows the SerDes reference clock input
Freescale Semiconductor
Figure 43
shows