s908gz60cfa Freescale Semiconductor, Inc, s908gz60cfa Datasheet - Page 270

• Manufacturer Part Number: s908gz60cfa
• Description: M68hc08 Microcontrollers
• Manufacturer: Freescale Semiconductor, Inc

Timer Interface Module (TIM1)
register 0 (TSCR0) controls and monitors the PWM signal from the linked channels. MS0B takes priority
over MS0A.
Clearing the toggle-on-overflow bit, TOVx, inhibits output toggles on TIM1 overflows. Subsequent output
compares try to force the output to a state it is already in and have no effect. The result is a 0% duty cycle
output.
Setting the channel x maximum duty cycle bit (CHxMAX) and setting the TOVx bit generates a 100% duty
cycle output. See
18.4 Interrupts
The following TIM1 sources can generate interrupt requests:
18.5 Wait Mode
The WAIT instruction puts the MCU in low power-consumption standby mode.
The TIM1 remains active after the execution of a WAIT instruction. In wait mode the TIM1 registers are
not accessible by the CPU. Any enabled CPU interrupt request from the TIM1 can bring the MCU out of
wait mode.
If TIM1 functions are not required during wait mode, reduce power consumption by stopping the TIM1
before executing the WAIT instruction.
18.6 TIM1 During Break Interrupts
A break interrupt stops the TIM1 counter and inhibits input captures.
The system integration module (SIM) controls whether status bits in other modules can be cleared during
the break state. The BCFE bit in the break flag control register (BFCR) enables software to clear status
bits during the break state. See
To allow software to clear status bits during a break interrupt, write a 1 to the BCFE bit. If a status bit is
cleared during the break state, it remains cleared when the MCU exits the break state.
To protect status bits during the break state, write a 0 to the BCFE bit. With BCFE at 0 (its default state),
software can read and write I/O registers during the break state without affecting status bits. Some status
bits have a two-step read/write clearing procedure. If software does the first step on such a bit before the
break, the bit cannot change during the break state as long as BCFE is at 0. After the break, doing the
second step clears the status bit.
270
•
•
TIM1 overflow flag (TOF) — The TOF bit is set when the TIM1 counter reaches the modulo value
programmed in the TIM1 counter modulo registers. The TIM1 overflow interrupt enable bit, TOIE,
enables TIM1 overflow CPU interrupt requests. TOF and TOIE are in the TIM1 status and control
register.
TIM1 channel flags (CH1F:CH0F) — The CHxF bit is set when an input capture or output compare
occurs on channel x. Channel x TIM CPU interrupt requests are controlled by the channel x
interrupt enable bit, CHxIE. Channel x TIM CPU interrupt requests are enabled when CHxIE =1.
CHxF and CHxIE are in the TIM1 channel x status and control register.
18.8.4 TIM1 Channel Status and Control
MC68HC908GZ60 • MC68HC908GZ48 • MC68HC908GZ32 Data Sheet, Rev. 6
Figure 15-21. Break Status Register
Registers.
(BSR).
Freescale Semiconductor