UPD70F3765GF-GAT-AX Renesas Electronics America, UPD70F3765GF-GAT-AX Datasheet - Page 707

• Manufacturer Part Number: UPD70F3765GF-GAT-AX
• Description: MCU 32BIT V850ES/JX3-H 128-LQFP
• Manufacturer: Renesas Electronics America
• Series: V850ES/Jx3-Hr

Specifications of UPD70F3765GF-GAT-AX

• Core Processor: RISC
• Core Size: 32-Bit
• Speed: 48MHz
• Connectivity: CSI, EBI/EMI, I²C, UART/USART, USB
• Peripherals: DMA, LVD, PWM, WDT
• Number Of I /o: 96
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 40K x 8
• Voltage - Supply (vcc/vdd): 2.85 V ~ 3.6 V
• Data Converters: A/D 12x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

V850ES/JG3-H, V850ES/JH3-H
15.6 Cautions
R01UH0042EJ0400 Rev.4.00
Sep 30, 2010
(1) When A/D converter is not used
(2) Input range of ANI0 to ANI11 pins
(3) Countermeasures against noise
(4) Alternate I/O
When the A/D converter is not used, the power consumption can be reduced by clearing the ADA0M0.ADA0CE bit
to 0.
Input the voltage within the specified range to the ANI0 to ANI11 pins. If a voltage equal to or higher than AV
equal to or lower than AV
the conversion value of that channel is undefined, and the conversion value of the other channels may also be
affected.
To maintain the 10-bit resolution, the ANI0 to ANI11 pins must be effectively protected from noise. The effect of
noise increases as the output impedance of the analog input source becomes higher. To lower the noise,
connecting an external capacitor as shown in Figure 15-12 is recommended.
The analog input pins (ANI0 to ANI11) function alternately as port pins. When selecting one of the ANI0 to ANI11
pins to execute A/D conversion, do not execute an instruction to read an input port or write to an output port during
conversion as the conversion resolution may drop.
Also the conversion resolution may drop at the pins set as output port pins during A/D conversion if the output
current fluctuates due to the effect of the external circuit connected to the port pins.
If a digital pulse is applied to a pin adjacent to the pin whose input signal is being converted, the A/D conversion
value may not be as expected due to the effect of coupling noise. Therefore, do not apply a pulse to a pin adjacent
to the pin undergoing A/D conversion.
SS
(even within the range of the absolute maximum ratings) is input to any of these pins,
Figure 15-12. Processing of Analog Input Pin
Clamp with a diode with a low V
if noise equal to or higher than AV
to or lower than AV
ANI0 to ANI11
V
AV
AV
V
DD
SS
REF0
SS
SS
may be generated.
CHAPTER 15 A/D CONVERTER
F
(0.3 V or less)
REF0
or equal
Page 707 of 1509
REF0
or