AT91SAM7X128 Atmel, AT91SAM7X128 Datasheet - Page 461

• Manufacturer Part Number: AT91SAM7X128
• Description: MCU 32-Bit 91S ARM7TDMI RISC 128KB Flash 1.8V/3.3V 100-Pin LQFP
• Manufacturer: Atmel

Specifications of AT91SAM7X128

• Package: 100LQFP
• Device Core: ARM7TDMI
• Family Name: 91S
• Maximum Speed: 55 MHz
• Ram Size: 32 KB
• Program Memory Size: 128 KB
• Operating Supply Voltage: 1.8|3.3 V
• Data Bus Width: 32 Bit
• Program Memory Type: Flash
• Number Of Programmable I/os: 62
• Interface Type: CAN/Ethernet/SPI/I2S/TWI/USART/USB
• On-chip Adc: 8-chx10-bit
• Operating Temperature: -40 to 85 °C
• Number Of Timers: 3

6120H–ATARM–17-Feb-09
When a setup transaction is received after a stall handshake, STALLSENT must be cleared in
order to prevent interrupts due to STALLSENT being set.
Figure 34-12. Stall Handshake (Data IN Transfer)
Figure 34-13. Stall Handshake (Data OUT Transfer)
3. The microcontroller is notified that the device has sent the stall by polling the
USB Bus
Packets
FORCESTALL
STALLSENT
USB Bus
Packets
FORCESTALL
STALLSENT
STALLSENT to be set. An endpoint interrupt is pending while STALLSENT is set. The
microcontroller must clear STALLSENT to clear the interrupt.
Data OUT PID
AT91SAM7X512/256/128 Preliminary
Data IN
PID
Set by USB Device
Data OUT
Stall PID
Set by Firmware
Stall PID
Set by Firmware
Interrupt Pending
Interrupt Pending
Set by
USB Device
Cleared by Firmware
Cleared by Firmware
Cleared by Firmware
461