AT91SAM7X128 Atmel, AT91SAM7X128 Datasheet - Page 544

• Manufacturer Part Number: AT91SAM7X128
• Description: MCU 32-Bit 91S ARM7TDMI RISC 128KB Flash 1.8V/3.3V 100-Pin LQFP
• Manufacturer: Atmel

Specifications of AT91SAM7X128

• Package: 100LQFP
• Device Core: ARM7TDMI
• Family Name: 91S
• Maximum Speed: 55 MHz
• Ram Size: 32 KB
• Program Memory Size: 128 KB
• Operating Supply Voltage: 1.8|3.3 V
• Data Bus Width: 32 Bit
• Program Memory Type: Flash
• Number Of Programmable I/os: 62
• Interface Type: CAN/Ethernet/SPI/I2S/TWI/USART/USB
• On-chip Adc: 8-chx10-bit
• Operating Temperature: -40 to 85 °C
• Number Of Timers: 3

• AERR: Acknowledgment Error
0 = No acknowledgment error occurred during a previous transfer.
1 = An acknowledgment error occurred during a previous transfer.
An acknowledgment error is detected when no detection of the dominant bit in the acknowledge slot occurs.
This flag is automatically cleared by reading CAN_SR register.
• FERR: Form Error
0 = No form error occurred during a previous transfer
1 = A form error occurred during a previous transfer
A form error results from violations on one or more of the fixed form of the following bit fields:
This flag is automatically cleared by reading CAN_SR register.
• BERR: Bit Error
0 = No bit error occurred during a previous transfer.
1 = A bit error occurred during a previous transfer.
A bit error is set when the bit value monitored on the line is different from the bit value sent.
This flag is automatically cleared by reading CAN_SR register.
• RBSY: Receiver busy
0 = CAN receiver is not receiving a frame.
1 = CAN receiver is receiving a frame.
Receiver busy. This status bit is set by hardware while CAN receiver is acquiring or monitoring a frame (remote, data, over-
load or error frame). It is automatically reset when CAN is not receiving.
• TBSY: Transmitter busy
0 = CAN transmitter is not transmitting a frame.
1 = CAN transmitter is transmitting a frame.
Transmitter busy. This status bit is set by hardware while CAN transmitter is generating a frame (remote, data, overload or
error frame). It is automatically reset when CAN is not transmitting.
• OVLSY: Overload busy
0 = CAN transmitter is not transmitting an overload frame.
1 = CAN transmitter is transmitting a overload frame.
It is automatically reset when the bus is not transmitting an overload frame.
6120H–ATARM–17-Feb-09
– CRC delimiter
– ACK delimiter
– End of frame
– Error delimiter
– Overload delimiter
AT91SAM7X512/256/128 Preliminary
544