C8051F226DK Silicon Laboratories Inc, C8051F226DK Datasheet - Page 94

• Manufacturer Part Number: C8051F226DK
• Description: DEV KIT F220/221/226/230/231/236
• Manufacturer: Silicon Laboratories Inc
• Type: MCUr

Specifications of C8051F226DK

• Contents: Evaluation Board, Power Supply, USB Cables, Adapter and Documentation
• Processor To Be Evaluated: C8051F22x and C8051F23x
• Interface Type: USB
• Silicon Manufacturer: Silicon Labs
• Core Architecture: 8051
• Silicon Core Number: C8051F226
• Silicon Family Name: C8051F2xx
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: C8051F220, 221, 226, 230, 231, 236
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 336-1241

C8051F2xx
Disable WDT
Writing 0xDE followed by 0xAD to the WDTCN register disables the WDT. The following code segment
illustrates disabling the WDT.
The writes of 0xDE and 0xAD must occur within 4 clock cycles of each other, or the disable operation is
ignored. Interrupts should be disabled during this procedure to avoid delay between the two writes.
Disable WDT Lockout
Writing 0xFF to WDTCN locks out the disable feature. Once locked out, the disable operation is ignored
until the next system reset. Writing 0xFF does not enable or reset the watchdog timer. Applications alays
intending to use the watchdog should write 0xFF to WDTCN in their initialization code.
Setting WDT Interval
WDTCN.[2:0] control the watchdog timeout interval. The interval is given by the following equation:
For a 2.0 MHz system clock, this provides an interval range of 32msec to 524msec. WDTCN.7 must be
written as 0 when setting this interval. Reading WDTCN returns the programmed interval. WDTCN.[2:0] is
111b after a system reset.
94
Bits7–0: WDT Control
Bit4:
Bits2–0: Watchdog Timeout Interval Bits
CLR
MOV
MOV
SETB
R/W
Bit7
EA
WDTCN,#0DEh
WDTCN,#0ADh
EA
Writing 0xA5 both enables and reloads the WDT.
Writing 0xDE followed within 4 clocks by 0xAD disables the WDT.
Writing 0xFF locks out the disable feature.
Watchdog Status Bit (when Read)
Reading the WDTCN.[4] bit indicates the Watchdog Timer Status.
0: WDT is inactive
1: WDT is active
The WDTCN.[2:0] bits set the Watchdog Timeout Interval. When writing these bits,
WDTCN.7 must be set to 0.
R/W
Bit6
4
SFR Definition 12.1. WDTCN: Watchdog Timer Control
3+WDTCN[2:0]
R/W
Bit5
; disable all interrupts
; disable watchdog timer
;
; re-enable interrupts
x T
SYSCLK
R/W
Bit4
, (where T
Rev. 1.6
R/W
Bit3
SYSCLK
is the system clock period).
R/W
Bit2
R/W
Bit1
R/W
Bit0
SFR Address:
Reset Value
xxxxx111
0xFF