MC68HC912B32MFU8 MOTOROLA [Motorola, Inc], MC68HC912B32MFU8 Datasheet - Page 37

• Manufacturer Part Number: MC68HC912B32MFU8
• Description: 16-Bit Microcontroller
• Manufacturer: MOTOROLA [Motorola, Inc]

7 Flash EEPROM
7.1 Overview
7.2 Flash EEPROM Control Block
7.3 Flash EEPROM Array
7.4 Flash EEPROM Registers
FEELCK — Flash EEPROM Lock Control Register
LOCK — Lock Register Bit
MC68HC912B32
MC68HC912B32TS/D
RESET:
The 32-Kbyte Flash EEPROM module for the MC68HC912B32 serves as electrically erasable and pro-
grammable, non-volatile ROM emulation memory. The module can be used for program code that must
either execute at high speed or is frequently executed, such as operating system kernels and standard
subroutines, or it can be used for static data which is read frequently. The Flash EEPROM is ideal for
program storage for single-chip applications allowing for field reprogramming.
The Flash EEPROM array is arranged in a 16-bit configuration and may be read as either bytes, aligned
words or misaligned words. Access time is one bus cycle for byte and aligned word access and two bus
cycles for misaligned word operations.
The Flash EEPROM module requires an external program/erase voltage (V
Flash EEPROM array. The external program/erase voltage is provided to the Flash EEPROM module
via an external V
equal to V
erase only.
The Flash EEPROM module has hardware interlocks which protect stored data from accidental corrup-
tion. An erase- and program-protected 2-Kbyte block for boot routines is located at $7800–$7FFF or
$F800–$FFFF depending upon the mapped location of the Flash EEPROM array. (The protected boot
block on the initial mask sets, G86W and G75R, is 1-Kbyte and is located at $7C00–$7FFF or $FC00–
$FFFF.)
A 4-byte register block controls the Flash EEPROM module operation. Configuration information is
specified and programmed independently from the contents of the Flash EEPROM array. At reset, the
4-byte register section starts at address $00F4.
After reset, the Flash EEPROM array is located from addresses $8000 to $FFFF in single-chip mode.
In Expanded modes the Flash EEPROM array is located from address $0000 to $7FFF, however, it is
turned off. The Flash EEPROM can be mapped to an alternate address range. See 5 Operating Modes
and Resource Mapping.
In normal modes the LOCK bit can only be written once after reset.
0 = Enable write to FEEMCR register
1 = Disable write to FEEMCR register
Bit 7
DD
0
0
.5V. Programming is by byte or aligned word. The Flash EEPROM module supports bulk
FP
pin. To prevent damage to the flash array, V
6
0
0
5
0
0
4
0
0
3
0
0
2
0
0
FP
should always be greater than or
FP
1
0
0
) to program or erase the
LOCK
Bit 0
0
MOTOROLA
$00F4
37