UPD78F9222MC(T)-5A4-A NEC, UPD78F9222MC(T)-5A4-A Datasheet - Page 142

• Manufacturer Part Number: UPD78F9222MC(T)-5A4-A
• Description: 8BIT MCU, 4K FLASH, 256B RAM, 78F9222
• Manufacturer: NEC

Specifications of UPD78F9222MC(T)-5A4-A

• Controller Family/series: UPD78
• No. Of I/o's: 17
• Ram Memory Size: 256Byte
• Cpu Speed: 10MHz
• No. Of Timers: 4
• No. Of: RoHS Compliant
• Core Size: 8bit
• Program Memory Size: 4KB
• Oscillator Type: External, Internal

frequency is f
142
If the setting value of the CMP01 register is N, the setting value of the CMP11 register is M, and the count clock
<4> When 8-bit timer counter H1 and the CMP11 register match, TOH1 output becomes inactive and the
<5> By performing procedures <3> and <4> repeatedly, a pulse with an arbitrary duty can be obtained.
<6> To stop the count operation, set TMHE1 = 0.
Cautions 1. In PWM output mode, the setting value for the CMP11 register can be changed during timer
compare register to be compared with 8-bit timer counter H1 is changed from the CMP11 register to the
CMP01 register.
generated.
CNT
2. Be sure to set the CMP11 register when starting the timer count operation (TMHE1 = 1) after
, the PWM pulse output cycle and duty are as follows.
PWM pulse output cycle = (N+1)/f
Duty = Active width : Total width of PWM = (M + 1) : (N + 1)
count operation. However, three operation clocks (signal selected using the CKS12 to
CKS10 bits of the TMHMD1 register) or more are required to transfer the register value after
rewriting the CMP11 register value.
the timer count operation was stopped (TMHE1 = 0) (be sure to set again even if setting the
same value to the CMP11 register).
At this time, 8-bit timer counter H1 is not cleared and the INTTMH1 signal is not
CHAPTER 8 8-BIT TIMER H1
User’s Manual U16898EJ5V0UD
CNT