W7100A-64QFN WIZnet, W7100A-64QFN Datasheet - Page 132

• Manufacturer Part Number: W7100A-64QFN
• Description: 8-bit Microcontrollers - MCU 8051 CORE+HARDWIRED TCP/IP+MAC+PHY
• Manufacturer: WIZnet

Specifications of W7100A-64QFN

• Rohs: yes
• Interface Type: UART

© Copyright 2011 WIZnet Co., Inc. All rights reserved.
information about the transmitter (IP address) and the length of the DATA-packet. The data
reception of IPRAW is the same as UDP data reception except processing the port number of
the transmitter in UDP PACKET-INFO. Refer to the section 9.2.2.1 ‘Unicast & Broadcast’.
receive that DATA and also cannot receive fragmented DATA.

default MTU. The transmission of IPRAW data is the same as transmission of UDP data except
setting ‘Destination port number’. Refer to the section 9.2.2.1 ‘Unicast & Broadcast’.


9.2.4
protocol to suit the host’s needs.
mode, not only can it use the SOCKET1~7 in the ‘Hardwired TCP/IP stack’, but it can also be
used as a NIC (Network Interface Controller). Therefore, any SOCKET1~7 can be used with
‘Software TCP/IP stack’. Since the W7100A supports ‘Hardwired TCP/IP stack’ and ‘Software
TCP/IP stack’, it calls ‘Hybrid TCP/IP stack’. If user wants more SOCKETs beyond the
supported 8 SOCKETS, the SOCKET in which the user wants high performance should be
utilizing the ‘‘Hardwired TCP/IP stack’, and the others should be using ‘Software TCP/IP
stack’ by MACRAW mode. So it overcomes the limited capacity of 8 SOCKETS. The SOCKET of
MACRAW mode can process all protocols except using in SOCKET1~7. Since the MACRAW
communication is pure Ethernet packet communication (there is no other processing), the
MACRAW designer should use the ‘Software TCP/IP stack’ to process the protocol. The
The IPRAW data consists of 6bytes PACKET-INFO and DATA packet. The PACKET-INFO contains
If the transmitted DATA size is larger than RX memory free size of SOCKET n, user cannot
The size of DATA which user wants to transmit cannot be larger than Internal TX memory and
Same as UDP, please refer to the section 9.2.2 ‘UDP’.
Same as UDP, please refer to the section 9.2.2 ‘UDP’.
The MACRAW communication is based on Ethernet MAC, and it can flexibly use upper layer
The MACRAW mode can only be used with a SOCKET. If the user uses the SOCKET in MACRAW
Check send data / Sending process
Complete sending / Timeout
Check finished / SOCKET closed
MACRAW
Figure 9.8 The received IPRAW data format
Ver. 1.12
132