R88M-WP10030S-WS1 Omron, R88M-WP10030S-WS1 Datasheet - Page 385

• Manufacturer Part Number: R88M-WP10030S-WS1
• Description: SERVO MOTOR 100W 100V
• Manufacturer: Omron

Specifications of R88M-WP10030S-WS1

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: R88MWP10030SWS1

Operation
Note 2. Perform rough adjustments in units of 10°, and fine adjustments in units of 1°. (You can also
Note 3. Do not greatly adjust either U phase or V phase alone.
Operation Procedure
Note The digits you can manipulate will flash.
Repeat the above operation (phase-U adjustment to phase-V adjustment) until the torque ripple improves
no further even by changing the offset in both the + and – directions. Next, finely adjust the phase U and
phase V in the same way.
operation
PR02W
perform intermediate adjustments in units of 5°.)
key operation
Front panel
(1 s max.)
(1 s max.)
(1 s max.)
(1 s max.)
(1 s min.)
(1 s min.)
Display
Press the MODE/SET Key to change to System Check
Mode.
Press the Up or Down Key to set function code Fn00F.
(See note.)
Press the DATA Key (front panel: DATA Key for 1 s min.)
to display “Cu1_o” (U phase)
Press the Left Key (front panel: DATA Key for less than
1 s) or Right Key to display the U-phase offset amount.
Press the Up or Down Key to change the offset amount.
Change the offset in units of 10° in the direction in which
the torque ripple is reduced.
Press the Left Key (front panel: DATA Key for less than
1 s) or Right Key to return to the “Cu1_o” display.
Press the MODE/SET Key to display “Cu2_o.” (V
phase).
Press the Left Key (front panel: DATA Key for less than
1 s) or Right Key to display the V-phase offset amount.
Press the Up or Down Key to change the offset amount.
Change the offset in units of 10° in the direction in which
the torque ripple is reduced.
Press the Left Key (front panel: DATA Key for less than
1 s) or Right Key to return to the “Cu2_o” display.
Press the MODE/SET Key to display “Cu1_o.”
When you have completed the Servomotor current
detection offset adjustment, press the DATA Key (front
panel: DATA Key for 1 s min.) to return to the System
Check Mode function code display.
Explanation
Chapter 4
4-147