MC8640DTHX1067NE Freescale Semiconductor, MC8640DTHX1067NE Datasheet - Page 75

• Manufacturer Part Number: MC8640DTHX1067NE
• Description: IC MPU DUAL CORE E600 1023FCCBGA
• Manufacturer: Freescale Semiconductor

Specifications of MC8640DTHX1067NE

• Processor Type: MPC86xx PowerPC 32-Bit
• Speed: 1.067GHz
• Voltage: 0.95V
• Mounting Type: Surface Mount
• Package / Case: 1023-FCCBGA
• Processor Series: MPC8xxx
• Core: e600
• Development Tools By Supplier: MCEVALHPCN-8641D
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Features: -
• Lead Free Status / Rohs Status: No

14.5.1
The AC timing and voltage parameters must be verified at the measurement point, as specified within 0.2
inches of the package pins, into a test/measurement load shown in
15 Serial RapidIO
This section describes the DC and AC electrical specifications for the RapidIO interface of the MPC8640,
for the LP-Serial physical layer. The electrical specifications cover both single and multiple-lane links.
Two transmitter types (short run and long run) on a single receiver are specified for each of three baud
rates, 1.25, 2.50, and 3.125 GBaud.
Two transmitter specifications allow for solutions ranging from simple board-to-board interconnect to
driving two connectors across a backplane. A single receiver specification is given that will accept signals
from both the short run and long run transmitter specifications.
The short run transmitter specifications should be used mainly for chip-to-chip connections on either the
same printed circuit board or across a single connector. This covers the case where connections are made
to a mezzanine (daughter) card. The minimum swings of the short run specification reduce the overall
power used by the transceivers.
The long run transmitter specifications use larger voltage swings that are capable of driving signals across
backplanes. This allows a user to drive signals across two connectors and a backplane. The specifications
allow a distance of at least 50 cm at all baud rates.
All unit intervals are specified with a tolerance of ± 100 ppm. The worst case frequency difference between
any transmit and receive clock will be 200 ppm.
Freescale Semiconductor
Compliance Test and Measurement Load
MPC8640 and MPC8640D Integrated Host Processor Hardware Specifications, Rev. 3
The allowance of the measurement point to be within 0.2 inches of the
package pins is meant to acknowledge that package/board routing may
benefit from D+ and D– not being exactly matched in length at the package
pin boundary.
Figure 52. Compliance Test/Measurement Load
NOTE
Figure
52.
Serial RapidIO
75