AT32UC3C2256C Atmel Corporation, AT32UC3C2256C Datasheet - Page 597

• Manufacturer Part Number: AT32UC3C2256C
• Manufacturer: Atmel Corporation

Specifications of AT32UC3C2256C

• Flash (kbytes): 256 Kbytes
• Pin Count: 64
• Max. Operating Frequency: 66 MHz
• Cpu: 32-bit AVR
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 45
• Ext Interrupts: 64
• Usb Transceiver: 1
• Quadrature Decoder Channels: 1
• Usb Speed: Full Speed
• Usb Interface: Device + OTG
• Spi: 5
• Twi (i2c): 2
• Uart: 4
• Can: 2
• Lin: 4
• Ssc: 1
• Ethernet: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 11
• Adc Resolution (bits): 12
• Adc Speed (ksps): 2000
• Analog Comparators: 2
• Resistive Touch Screen: No
• Dac Channels: 2
• Dac Resolution (bits): 12
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 68
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.0 to 3.6 or 4.5 to 5.5
• Operating Voltage (vcc): 3.0 to 3.6 or 4.5 to 5.5
• Fpu: Yes
• Mpu / Mmu: Yes / No
• Timers: 3
• Output Compare Channels: 13
• Input Capture Channels: 6
• Pwm Channels: 14
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

25.6.8.2
32117C–AVR-08/11
Baud Rate
In SPI Mode, the baudrate generator operates in the same way as in USART synchronous
mode:
In SPI Master Mode:
In SPI Slave Mode:
• the external clock CLK must not be selected (USCLKS … 0x3), and the bit CLKO must be set
• to obtain correct behavior of the receiver and the transmitter, the value programmed in CD of
• if the internal clock divided (CLK_USART/DIV) is selected, the value programmed in CD must
• the external clock (CLK) selection is forced regardless of the value of the USCLKS field in the
• to obtain correct behavior of the receiver and the transmitter, the external clock (CLK)
to “1” in the Mode Register (MR), in order to generate correctly the serial clock on the CLK
pin.
must be superior or equal to 4.
be even to ensure a 50:50 mark/space ratio on the CLK pin, this value can be odd if the
internal clock is selected (CLK_USART).
Mode Register (MR). Likewise, the value written in BRGR has no effect, because the clock is
provided directly by the signal on the USART CLK pin.
frequency must be at least 4 times lower than the system clock.
See Section “25.6.1.4” on page 569.
However, there are some restrictions:
AT32UC3C
597