AT32UC3C2256C Atmel Corporation, AT32UC3C2256C Datasheet - Page 603

• Manufacturer Part Number: AT32UC3C2256C
• Manufacturer: Atmel Corporation

Specifications of AT32UC3C2256C

• Flash (kbytes): 256 Kbytes
• Pin Count: 64
• Max. Operating Frequency: 66 MHz
• Cpu: 32-bit AVR
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 45
• Ext Interrupts: 64
• Usb Transceiver: 1
• Quadrature Decoder Channels: 1
• Usb Speed: Full Speed
• Usb Interface: Device + OTG
• Spi: 5
• Twi (i2c): 2
• Uart: 4
• Can: 2
• Lin: 4
• Ssc: 1
• Ethernet: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 11
• Adc Resolution (bits): 12
• Adc Speed (ksps): 2000
• Analog Comparators: 2
• Resistive Touch Screen: No
• Dac Channels: 2
• Dac Resolution (bits): 12
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 68
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.0 to 3.6 or 4.5 to 5.5
• Operating Voltage (vcc): 3.0 to 3.6 or 4.5 to 5.5
• Fpu: Yes
• Mpu / Mmu: Yes / No
• Timers: 3
• Output Compare Channels: 13
• Input Capture Channels: 6
• Pwm Channels: 14
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

25.6.9.6
Figure 25-39. Header Transmission
32117C–AVR-08/11
Baud Rate
TXRDY
LINIR
LINIR
Clock
Write
TXD
Header Transmission (Master Node Configuration)
ID
13 dominant bits (at 0)
All the LIN Frames start with a header which is sent by the master node and consists of a Synch
Break Field, Synch Field and Identifier Field.
So in Master node configuration, the frame handling starts with the sending of the header.
The header is transmitted as soon as the identifier is written in the LIN Identifier register (LINIR).
At this moment the flag TXRDY falls.
The Break Field, the Synch Field and the Identifier Field are sent automatically one after the
other.
The Break Field consists of 13 dominant bits and 1 recessive bit, the Synch Field is the charac-
ter 0x55 and the Identifier corresponds to the character written in the LIN Identifier Register
(LINIR). The Identifier parity bits can be automatically computed and sent (see
25.6.9.9).
The bit TXRDY is set when the identifier character is transferred into the Shift Register of the
transmitter.
Break Field
1 recessive bit
Delimiter
Break
(at 1)
Start
Bit
1
0
Synch Byte = 0x55
1
0
1
0
1
0
Stop
Bit
Start
Bit
ID0 ID1 ID2 ID3 ID4 ID5 ID6 ID7
AT32UC3C
Stop
Bit
Section
603