AT86RF212 Atmel Corporation, AT86RF212 Datasheet - Page 48

• Manufacturer Part Number: AT86RF212
• Manufacturer: Atmel Corporation

Specifications of AT86RF212

• Max. Operating Frequency: 0 MHz
• Crypto Engine: AES
• Operating Voltage (vcc): 1.8 to 3.6
• Frequency Band: 700/800/900MHz
• Max Data Rate (mb/s): 1
• Antenna Diversity: No
• External Pa Control: Yes
• Power Output (dbm): 10
• Receiver Sensitivity (dbm): -110
• Receive Current Consumption (ma): 9.0
• Transmit Current Consumption (ma): 18 at 5dBm
• Link Budget (dbm): 120

5.2.3.1 Configuration Registers
5.2.3.2 Configuration of IEEE Compliant Scenarios
48
AT86RF212
RX_AACK configuration as described below shall be done prior to switching the
AT86RF212 into state RX_AACK_ON, refer to section 5.2.1.
Table 5-8 summarizes all register bits which affect the behavior of an RX_AACK
transaction. For frame filtering it is further required to setup address registers to match
to the expected address.
Table 5-8. Overview of RX_AACK Configuration Bits
The usage of the RX_AACK configuration bits for various device types or operating
modes is explained in the following sections. Configuration bits not mentioned in the
following two sections should be set to their reset values according to Table 11-2.
All registers mentioned in Table 5-8 are described in section 5.2.6.
Device not operating as a PAN Coordinator
Table 5-9 shows the RX_AACK configuration registers, required to setup a typical
IEEE 802.15.4 compliant device.
0x20,0x21
0x22,0x23
Register
Address
0x0C
0x2C
0x2B
0x2E
0x2E
0x2E
0x2E
0x24
0x17
0x17
0x17
0x17
…
Register
7:6
Bit
7
1
2
4
5
0
3
4
5
Name
SHORT_ADDR_0/1
PAN_ADDR_0/1
IEEE_ADDR_0
…
IEEE_ADDR_7
RX_SAFE_MODE
AACK_PROM_MODE
AACK_ACK_TIME
AACK_UPLD_RES_FT
AACK_FLTR_RES_FT
SLOTTED_OPERATION
AACK_I_AM_COORD
AACK_DIS_ACK
AACK_SET_PD
AACK_FVN_MODE
Enable promiscuous mode
Description
Setup Frame Filter, see section 6.2.1
Dynamic frame buffer protection, see
section 9.7
Modify auto acknowledge start time
Enable reserved frame type reception,
needed to receive non-standard compliant
frames, see section 5.2.3.3
Filter reserved frame types like data frame
type, needed for filtering of non-standard
compliant frames, see section 5.2.3.3
If set, acknowledgment transmission has
to be triggered by pin 11 (SLP_TR), see
section 4.6
Define device as PAN coordinator, see
section 5.2.3.2
Disable generation of acknowledgment
Signal pending data in Frame Control
Field (FCF) of acknowledgement
Control the ACK generation, depending
on FCF frame version number
8168C-MCU Wireless-02/10