AT86RF212 Atmel Corporation, AT86RF212 Datasheet - Page 72

• Manufacturer Part Number: AT86RF212
• Manufacturer: Atmel Corporation

Specifications of AT86RF212

• Max. Operating Frequency: 0 MHz
• Crypto Engine: AES
• Operating Voltage (vcc): 1.8 to 3.6
• Frequency Band: 700/800/900MHz
• Max Data Rate (mb/s): 1
• Antenna Diversity: No
• External Pa Control: Yes
• Power Output (dbm): 10
• Receiver Sensitivity (dbm): -110
• Receive Current Consumption (ma): 9.0
• Transmit Current Consumption (ma): 18 at 5dBm
• Link Budget (dbm): 120

6.2.1 Configuration
72
AT86RF212
Address matching, indicated by interrupt IRQ_5 (AMI), is furthermore controlled by the
FCF of a received frame according to the following rule: If Destination Addressing Mode
is 0/1 and Source Addressing Mode is 0 (see section 6.1.2.2), no interrupt IRQ_5 is
generated. This causes that no acknowledgement frame is announced.
For backward compatibility with IEEE 802.15.4-2003, the third level filter rule 2 (Frame
Version) can be disabled by register bits AACK_FVN_MODE (register 0x2E,
CSMA_SEED_1).
Frame filtering is available in Extended and Basic Operating Modes. A frame that
passes the Frame Filter generates the interrupt IRQ_5 (AMI) if not masked.
Notes
• Filter
• Filter rule 2 is affected by register bits AACK_FVN_MODE, see section 6.2.3.
The Frame Filter is configured by setting the appropriate address variables and several
additional properties as described in Table 6-6.
Table 6-6. Frame Filter Configuration
0x20,0x21
0x22,0x23
Register
Address
AACK_UPLD_RES_FT, see section 6.2.3.
0x2B
0x2E
0x24
0x17
0x17
0x17
…
rule
Register
Bits
7:0
7:6
1
1
4
5
is
Name
SHORT_ADDR_0/1
PAN_ADDR_0/1
IEEE_ADDR_0
…
IEEE_ADDR_7
AACK_PROM_MODE
AACK_UPLD_RES_FT
AACK_FLTR_RES_FT
AACK_FVN_MODE
affected
by
register
Description
Set macShortAddress, macPANId , and
aExtendedAddress as described in [2]
0: Disable promiscuous mode
1: Enable promiscuous mode
0: Disable reserved frame type reception
1: Enable reserved frame type reception
Filter reserved frame types like data frame
type, see section 6.2.2
0: Disable
1: Enable
Frame acceptance criteria depending on
FCF frame version number
b00: Accept only frames with version
number 0, i.e. according to
IEEE 802.15.4-2003 frames
b01: Accept only frames with version
number 0 or 1, i.e. frames according to
IEEE 802.15.4-2006
b10: Accept only frames with version
number 0 or 1 or 2
b11: Accept all frames, independent of the
FCF frame version number
bits
AACK_FLTR_RES_FT
8168C-MCU Wireless-02/10
and