R5F212D8SNFP#U0 Renesas Electronics America, R5F212D8SNFP#U0 Datasheet - Page 471

• Manufacturer Part Number: R5F212D8SNFP#U0
• Description: IC R8C/2D MCU FLASH 64KB 80-LQFP
• Manufacturer: Renesas Electronics America
• Series: R8C/2x/2Dr

Specifications of R5F212D8SNFP#U0

• Core Processor: R8C
• Core Size: 16/32-Bit
• Speed: 20MHz
• Connectivity: I²C, LIN, SIO, SSU, UART/USART
• Peripherals: POR, PWM, Voltage Detect, WDT
• Number Of I /o: 71
• Program Memory Size: 64KB (64K x 8)
• Program Memory Type: FLASH
• Ram Size: 3K x 8
• Voltage - Supply (vcc/vdd): 2.2 V ~ 5.5 V
• Data Converters: A/D 20x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 85°C
• Package / Case: 80-LQFP
• For Use With: R0K5212D8S001BE - KIT STARTER FOR R8C/2DR0K5212D8S000BE - KIT DEV FOR R8C/2D
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

R8C/2C Group, R8C/2D Group
Rev.2.00
REJ09B0339-0200
16.3.3.5
In slave receive mode, the master device outputs the transmit clock and data, and the slave device returns an
acknowledge signal.
Figures 16.41 and 16.42 show the Operating Timing in Slave Receive Mode (I
The receive procedure and operation in slave receive mode are as follows.
(1) Set the ICE bit in the ICCR1 register to 1 (transfer operation enabled). Set bits WAIT and MLS in the
(2) When the slave address matches at the 1st frame after detecting the start condition, the slave device
(3) Read the ICDRR register every time the RDRF bit is set to 1. If the 8th clock cycle falls while the
(4) Reading the last byte is performed by reading the ICDRR register in like manner.
Dec 05, 2007
ICMR register and bits CKS0 to CKS3 in the ICCR1 register (initial setting). Set bits TRS and MST in
the ICCR1 register to 0 and wait until the slave address matches in slave receive mode.
outputs the level set in the ACKBT bit in the ICIER register to the SDA pin at the rise of the 9th clock
cycle. Since the RDRF bit in the ICSR register is set to 1 simultaneously, perform the dummy read (the
read data is unnecessary because it indicates the slave address and R/W).
RDRF bit is set to 1, the SCL signal is fixed “L” until the ICDRR register is read. The setting change of
the acknowledge signal returned to the master device before reading the ICDRR register takes affect
from the following transfer frame.
Slave Receive Operation
Page 448 of 585
16. Clock Synchronous Serial Interface
2
C bus Interface Mode).