HD64F3026X25 Renesas Electronics America, HD64F3026X25 Datasheet - Page 489

• Manufacturer Part Number: HD64F3026X25
• Description: MCU 3V 256K 100-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300Hr

Specifications of HD64F3026X25

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 25MHz
• Connectivity: SCI, SmartCard
• Peripherals: PWM, WDT
• Number Of I /o: 70
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Bit 7—Trigger Enable (TRGE): Enables or disables starting of A/D conversion by an external
trigger or 8-bit timer compare match.
Bit 7
TRGE
0
1
External trigger pin and 8-bit timer selection is performed by the 8-bit timer. For details, see
section 9, 8-Bit Timers.
Bits 6 to 1—Reserved: These bits cannot be modified and are always read as 1.
Bit 0—Reserved: This bit can be read or written, but must not be set to 1.
14.3
ADDRA to ADDRD are 16-bit registers, but they are connected to the CPU by an 8-bit data bus.
Therefore, although the upper byte can be be accessed directly by the CPU, the lower byte is read
through an 8-bit temporary register (TEMP).
An A/D data register is read as follows. When the upper byte is read, the upper-byte value is
transferred directly to the CPU and the lower-byte value is transferred into TEMP. Next, when the
lower byte is read, the TEMP contents are transferred to the CPU.
When reading an A/D data register, always read the upper byte before the lower byte. It is possible
to read only the upper byte, but if only the lower byte is read, incorrect data may be obtained.
Figure 14.2 shows the data flow for access to an A/D data register.
CPU Interface
Description
Starting of A/D conversion by an external trigger or 8-bit timer compare match is
disabled
A/D conversion is started at the falling edge of the external trigger signal (
by an 8-bit timer compare match
Rev. 2.00 Sep 20, 2005 page 449 of 800
Section 14 A/D Converter
REJ09B0260-0200
(Initial value)
A D T R G
) or