LAN91C111I-NS SMSC, LAN91C111I-NS Datasheet - Page 105

• Manufacturer Part Number: LAN91C111I-NS
• Description: IC ETHERNET CTLR MAC PHY 128-QFP
• Manufacturer: SMSC
• Type: Single Chip MAC and PHYr

Specifications of LAN91C111I-NS

• Controller Type: Ethernet Controller, MAC/PHY
• Interface: Serial EEPROM
• Voltage - Supply: 3.3V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 128-QFP
• Product: Ethernet Controllers
• Number Of Transceivers: 1
• Standard Supported: IEEE 802.3 or IEEE 802.3u
• Data Rate: 10 Mbps or 100 Mbps
• Supply Voltage (max): 5 V
• Supply Voltage (min): 0 V
• Supply Current (max): 140 mA
• Maximum Operating Temperature: + 85 C
• Ethernet Connection Type: 100BASE-T or 100BASE-T4 or 100BASE-TX or 10BASE-T
• Minimum Operating Temperature: - 40 C
• Mounting Style: SMD/SMT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Supply: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 638-1014

10/100 Non-PCI Ethernet Single Chip MAC + PHY
Datasheet
Chapter 13 Operational Description
SMSC LAN91C111 REV C
13.1
13.2
Schmitt Trigger Hysteresis
IS Type Input Buffer
I Type Input Buffer
I
High Input Level
High Input Level
High Input Level
Low Input Level
Low Input Level
Low Input Level
CLK
PARAMETER
Input Buffer
Maximum Guaranteed Ratings*
DC Electrical Characteristics
*Stresses above those listed above could cause permanent damage to the device. This is a stress
rating only and functional operation of the device at any other condition above those indicated in the
operation sections of this specification is not implied.
Note: When powering this device from laboratory or system power supplies, it is important that the
(V
Operating Temperature Range
Storage Temperature Range
Lead Temperature Range (soldering, 10
seconds)
Positive Voltage on any pin, with respect to
Ground
Negative Voltage on any pin, with respect to
Ground
Maximum V
CC
= +3.3.0 V ± 10%)
Absolute Maximum Ratings not be exceeded or device failure can result. Some power supplies
exhibit voltage spikes on their outputs when the AC power is switched on or off. In addition,
voltage transients on the AC power line may appear on the DC output. If this possibility exists,
it is suggested that a clamp circuit be used.
CC
SYMBOL
V
V
V
V
V
V
V
IHCK
ILCK
IHIS
HYS
ILIS
IHI
ILI
MIN
2.0
2.2
2.2
DATASHEET
105
TYP
250
0°C to +70°C for LAN91C111 (-40°C to 85°C for
LAN91C111I)
-55C° to + 150°C
+325°C
V
-0.3V
+5V
CC
MAX
+ 0.3V
0.8
0.8
0.8
UNITS
mV
V
V
V
V
V
V
Schmitt Trigger
Schmitt Trigger
Revision 1.91 (06-01-09)
COMMENTS
TTL Levels