LAN91C111I-NS SMSC, LAN91C111I-NS Datasheet - Page 77

• Manufacturer Part Number: LAN91C111I-NS
• Description: IC ETHERNET CTLR MAC PHY 128-QFP
• Manufacturer: SMSC
• Type: Single Chip MAC and PHYr

Specifications of LAN91C111I-NS

• Controller Type: Ethernet Controller, MAC/PHY
• Interface: Serial EEPROM
• Voltage - Supply: 3.3V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 128-QFP
• Product: Ethernet Controllers
• Number Of Transceivers: 1
• Standard Supported: IEEE 802.3 or IEEE 802.3u
• Data Rate: 10 Mbps or 100 Mbps
• Supply Voltage (max): 5 V
• Supply Voltage (min): 0 V
• Supply Current (max): 140 mA
• Maximum Operating Temperature: + 85 C
• Ethernet Connection Type: 100BASE-T or 100BASE-T4 or 100BASE-TX or 10BASE-T
• Minimum Operating Temperature: - 40 C
• Mounting Style: SMD/SMT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Supply: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 638-1014

10/100 Non-PCI Ethernet Single Chip MAC + PHY
Datasheet
SMSC LAN91C111 REV C
9.5
TX_HDX
NP
R
R
0
0
Register 5. Auto-Negotiation Remote End Capability Register
NP - Next Page
A ‘1’ indicates the PHY wishes to exchange Next Page information.
ACK - Acknowledge
It is used by the Auto-negotiation function to indicate that a device has successfully received its Link
Partner’s Link code Word.
RF - Remote Fault
When set, an advertisement frame will be sent with the corresponding bit set. This in turn will cause
the PHY receiving it to set the Remote Fault bit in its Status register
T4 - 100BASE-T4
A '1' indicates the PHY is capable of 100BASE-T4
TX_FDX - 100BASE-TX Full Duplex Capable
A '1' indicates the PHY is capable of 100BASE-TX Full Duplex
TX_HDX - 100BASE-TX Half Duplex Capable
A '1' indicates the PHY is capable of 100BASE-TX Half Duplex
10_FDX - 10BASE-T Full Duplex Capable
A '1' indicates the PHY is capable of 10BASE-T Full Duplex
10_HDX - 10BASE-T Half Duplex Capable
A '1' indicates the PHY is capable of 10BASE-T Half Duplex
The management entity sets the value of this field prior to AutoNegotiation.
‘1’ in these bit indicates that the mode of operation that corresponds to these will be acceptable to be
auto-negotiated to. Only modes supported by the PHY can be set.
CSMA
A '1' indicates the PHY is capable of 802.3 CSMA Operation
The bit definitions are analogous to the Auto Negotiation Advertisement Register.
10_FDX
ACK
R
R
0
0
10_HDX
RF
R
R
0
0
Reserved
Reserved
DATASHEET
R
R
0
0
77
Reserved
Reserved
R
R
0
0
Reserved
Reserved
R
R
0
0
Reserved
T4
R
R
0
0
Revision 1.91 (06-01-09)
TX_FDX
CSMA
R
R
0
0