DF2117VLP20V Renesas Electronics America, DF2117VLP20V Datasheet - Page 724

• Manufacturer Part Number: DF2117VLP20V
• Description: IC H8S/2117 MCU FLASH 145TFLGA
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2100r

Specifications of DF2117VLP20V

• Core Processor: H8S/2600
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: FIFO, I²C, LPC, SCI, SmartCard
• Peripherals: POR, PWM, WDT
• Number Of I /o: 112
• Program Memory Size: 160KB (160K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 16x10b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 145-TFLGA
• For Use With: HS0005KCU11H - EMULATOR E10A-USB H8S(X),SH2(A)3DK2166 - DEV EVAL KIT H8S/2166
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Section 22 Flash Memory
• The user boot Mat can be programmed or erased only in boot mode and programmer mode.
• In boot mode, the user MAT and user boot MAT are totally erased. Then, the user MAT or
• In user boot mode, boot operation of the optional interface can be performed with mode pin
22.3
This LSI's flash memory is configured by the 160-Kbyte user MAT and 8-Kbyte user boot MAT.
The start address is allocated to the same address in the user MAT and user boot MAT. Therefore,
when program execution or data access is performed between two MATs, the MAT must be
switched by using FMATS.
The user MAT or user boot MAT can be read in all modes. However, the user boot MAT can be
programmed only in boot mode and programmer mode.
The size of the user MAT is different from that of the user boot MAT. An address that exceeds the
size of the 8-Kbyte user boot MAT should not be accessed. If the attempt is made, data is read as
an undefined value.
Rev. 3.00 Sep. 28, 2009 Page 678 of 910
REJ09B0350-0300
user boot MAT can be programmed by means of commands. Note that the contents of the
MAT cannot be read until this state.
Boot mode can be used for programming only the user boot MAT and then programming the
user MAT in user boot mode. Another way is to program only the user MAT since user boot
mode is not used.
settings different from those in user program mode.
Address H'000000
Address H'027FFF
Flash Memory MAT Configuration
<User MAT>
Figure 22.3 Flash Memory Configuration
160K bytes
Address H'001FFF
Address H'000000
<User boot MAT>
8K bytes