DF2117VLP20V Renesas Electronics America, DF2117VLP20V Datasheet - Page 774

• Manufacturer Part Number: DF2117VLP20V
• Description: IC H8S/2117 MCU FLASH 145TFLGA
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2100r

Specifications of DF2117VLP20V

• Core Processor: H8S/2600
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: FIFO, I²C, LPC, SCI, SmartCard
• Peripherals: POR, PWM, WDT
• Number Of I /o: 112
• Program Memory Size: 160KB (160K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 16x10b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 145-TFLGA
• For Use With: HS0005KCU11H - EMULATOR E10A-USB H8S(X),SH2(A)3DK2166 - DEV EVAL KIT H8S/2166
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Section 22 Flash Memory
22.11
Along with its on-board programming mode, this LSI also has a programmer mode as a further
mode for the writing and erasing of programs and data. In programmer mode, a general-purpose
PROM programmer that supports the device types shown in table 22.16 can be used to write
programs to the on-chip ROM without any limitation.
Table 22.16 Device Types Supported in Programmer Mode
Note:
22.12
The boot program initiated in boot mode performs serial communication using the host and on-
chip SCI_1. The serial communication interface specifications are shown below.
The boot program has three states.
1. Bit-rate-adjustment state
2. Inquiry/selection state
Rev. 3.00 Sep. 28, 2009 Page 728 of 910
REJ09B0350-0300
Target Memory MAT
User MAT
User boot MAT
In this state, the boot program adjusts the bit rate to achieve serial communication with the
host. Initiating boot mode enables starting of the boot program and entry to the bit-rate-
adjustment state. The program receives the command from the host to adjust the bit rate. After
adjusting the bit rate, the program enters the inquiry/selection state.
In this state, the boot program responds to inquiry commands from the host. The device name,
clock mode, and bit rate are selected. After selection of these settings, the program is made to
enter the programming/erasing state by the command for a transition to the
programming/erasing state. The program transfers the libraries required for erasure to the on-
chip RAM and erases the user MATs and user boot MATs before the transition.
* For the R4F2117 model, 160 kbytes of ROM space is available when the user MAT is
Programmer Mode
Standard Serial Communication Interface Specifications for Boot
Mode
selected. If programming is performed in programmer mode, H'FF data must be written
to address H'28000 to H'3FFFF with 256-kbyte capacity setting.
Size
256 kbytes*
8 kbytes
Device Type
FZTAT256V3A
FZTATUSBTV3A