LPC1113FHN33/303,5 NXP Semiconductors, LPC1113FHN33/303,5 Datasheet - Page 442

• Manufacturer Part Number: LPC1113FHN33/303,5
• Description: ARM Microcontrollers - MCU Cortex-M0 24 kB flash up to 8kB SRAM
• Manufacturer: NXP Semiconductors

Specifications of LPC1113FHN33/303,5

• Rohs: yes
• Core: ARM Cortex M0
• Processor Series: LPC1113
• Data Bus Width: 32 bit
• Maximum Clock Frequency: 50 MHz
• Program Memory Size: 24 KB
• Data Ram Size: 4 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 1.8 V to 3.6 V
• Operating Temperature Range: - 65 C to + 150 C
• Package / Case: HVQFN-33
• Mounting Style: SMD/SMT
• Factory Pack Quantity: 260

27.1 How to read this chapter
27.2 Features
27.3 Introduction
27.4 Description
27.5 Pin description
UM10398
User manual
The debug functionality is identical for all LPC111x, LPC11D14, and LPC11Cxx parts.
Debug functions are integrated into the ARM Cortex-M0. Serial wire debug functions are
supported. The ARM Cortex-M0 is configured to support up to four breakpoints and two
watchpoints.
Debugging with the LPC111x/LPC11Cxx uses the Serial Wire Debug mode.
The tables below indicate the various pin functions related to debug. Some of these
functions share pins with other functions which therefore may not be used at the same
time.
Table 417. Serial Wire Debug pin description
Pin Name
SWCLK
SWDIO
•
•
•
•
•
UM10398
Chapter 27: LPC111x/LPC11Cxx Serial Wire Debug (SWD)
Rev. 12 — 24 September 2012
Supports ARM Serial Wire Debug mode.
Direct debug access to all memories, registers, and peripherals.
No target resources are required for the debugging session.
Four breakpoints. Four instruction breakpoints that can also be used to remap
instruction addresses for code patches. Two data comparators that can be used to
remap addresses for patches to literal values.
Two data watchpoints that can also be used as triggers.
All information provided in this document is subject to legal disclaimers.
Type
Input
Input /
Output
Rev. 12 — 24 September 2012
Description
Serial Wire Clock. This pin is the clock for debug logic when in the
Serial Wire Debug mode (SWCLK). This pin is pulled up internally.
Serial wire debug data input/output. The SWDIO pin is used by an
external debug tool to communicate with and control the
LPC111x/LPC11Cxx. This pin is pulled up internally.
© NXP B.V. 2012. All rights reserved.
User manual
442 of 538