IPTR-DSPBUILDER Altera, IPTR-DSPBUILDER Datasheet - Page 379

• Manufacturer Part Number: IPTR-DSPBUILDER
• Description: DSP BUILDER SOFTWARE
• Manufacturer: Altera
• Type: DSPr

Specifications of IPTR-DSPBUILDER

• Function: DSP Builder
• License: Renewal License
• Software Application: IP CORE, DSP BUILDER
• Core Architecture: FPGA
• Core Sub-architecture: Arria, Cyclone, Stratix
• Supported Families: Arria GX, Arria II GX, Cyclone, Stratix
• Rohs Compliant: NA
• Lead Free Status / RoHS Status: Not applicable / Not applicable

Chapter 11: Boards Library
Cyclone II EP2C70 DSP Board
Table 11–3. Cyclone II EP2C70 DSP Board Blocks
Figure 11–4. Design Example for the Cyclone II EP2C70 DSP Board
© June 2010 Altera Corporation
f
Block
A2D_1 and A2D_2
D2A_1 and D2A_2
Dip Switch
LED0–LED7
PROTO and
PROTO1
Display0 and
Display1
SW2–SW5,
USER_RESETN
For information about setting up the board, refer to the
II Getting Started User
to the
Figure 11–4
Cyclone II DSP Development Board Reference
shows the design example for the Cyclone II EP2C70 DSP board.
Controls the 14-bit signed analog-to-digital converters. You can optionally specify
the clock signal.
Controls the 14-bit unsigned digital-to-analog converters.
Controls the user-definable dual in-line package switch (S1). You can optionally
specify the clock signal.
Controls eight user-definable LEDs (D2–D9).
Santa Cruz connectors, which control the prototyping area I/O. You can optionally
specify Input or Output node type, specify the input clock signal, and specify the
pin location for each connector (J15, J22, J23).
Controls two simple user-definable seven-segment LED displays (U32, U33).
Controls four user-definable push-button switches (SW2–SW5, and the user reset
push-button SW6). You can optionally specify the clock signal.
Guide. For information about supported hardware features, refer
Preliminary
Description
Manual.
DSP Development Kit, Cyclone
DSP Builder Standard Blockset Libraries
11–5