MC68HC908GP16CFB Freescale Semiconductor, MC68HC908GP16CFB Datasheet - Page 260

• Manufacturer Part Number: MC68HC908GP16CFB
• Description: MCU 8-BIT 16K FLASH 44-QFP
• Manufacturer: Freescale Semiconductor
• Series: HC08r

Specifications of MC68HC908GP16CFB

• Core Processor: HC08
• Core Size: 8-Bit
• Speed: 8MHz
• Connectivity: SCI, SPI
• Peripherals: LVD, POR, PWM
• Number Of I /o: 33
• Program Memory Size: 16KB (16K x 8)
• Program Memory Type: FLASH
• Ram Size: 512 x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 8x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 44-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Glossary
break interrupt — A software interrupt caused by the appearance on the internal address bus of the
bus — A set of wires that transfers logic signals.
bus clock — The bus clock is derived from the CGMOUT output from the CGM. The bus clock frequency,
byte — A set of eight bits.
C — The carry/borrow bit in the condition code register. The CPU08 sets the carry/borrow bit when an
CCR — See “condition code register.”
central processor unit (CPU) — The primary functioning unit of any computer system. The CPU controls
CGM — See “clock generator module (CGM).”
clear — To change a bit from 1 to 0; the opposite of set.
clock — A square wave signal used to synchronize events in a computer.
clock generator module (CGM) — A module in the M68HC08 Family. The CGM generates a base clock
comparator — A device that compares the magnitude of two inputs. A digital comparator defines the
computer operating properly module (COP) — A counter module in the M68HC08 Family that resets
condition code register (CCR) — An 8-bit register in the CPU08 that contains the interrupt mask bit and
control bit — One bit of a register manipulated by software to control the operation of the module.
control unit — One of two major units of the CPU. The control unit contains logic functions that
COP — See "computer operating properly module (COP)."
counter clock — The input clock to the TIM counter. This clock is the output of the TIM prescaler.
CPU — See “central processor unit (CPU).”
CPU08 — The central processor unit of the M68HC08 Family.
260
same value that is written in the break address registers.
f
addition operation produces a carry out of bit 7 of the accumulator or when a subtraction operation
requires a borrow. Some logical operations and data manipulation instructions also clear or set the
carry/borrow bit (as in bit test and branch instructions and shifts and rotates).
the execution of instructions.
signal from which the system clocks are derived. The CGM may include a crystal oscillator circuit and
or phase-locked loop (PLL) circuit.
equality or relative differences between two binary numbers.
the MCU if allowed to overflow.
five bits that indicate the results of the instruction just executed.
synchronize the machine and direct various operations. The control unit decodes instructions and
generates the internal control signals that perform the requested operations. The outputs of the
control unit drive the execution unit, which contains the arithmetic logic unit (ALU), CPU registers, and
bus interface.
op
, is equal to the frequency of the oscillator output, CGMXCLK, divided by four.
MC68HC908EY16 • MC68HC908EY8 Data Sheet, Rev. 10
Freescale Semiconductor