PM4328-PI PMC-Sierra, Inc., PM4328-PI Datasheet - Page 155
PM4328-PI
Manufacturer Part Number
PM4328-PI
Description
Framer, T1|E1|T3 Standard Format, 324-BGA
Manufacturer
PMC-Sierra, Inc.
Datasheet
1.PM4328-PI.pdf
(250 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
PM4328-PI
Manufacturer:
ATMEL
Quantity:
320
- Current page: 155 of 250
- Download datasheet (2Mb)
STANDARD PRODUCT
DATASHEET
PMC-2011596
PROPRIETARY AND CONFIDENTIAL
TDPR Lower Interrupt Threshold should be set to such a value that sufficient
warning of an underrun is given. The FULLE, LFILLE, OVRE, and UDRE bits
are all set to logic 1 so an interrupt on INTB is generated upon detection of a
FIFO full state, a FIFO depth below the lower limit threshold, a FIFO overrun, or
a FIFO underrun. The following procedure should be followed to transmit HDLC
packets:
1. Wait for a complete packet to be transmitted. Once data is available to be
2. Write the data byte to the TDPR Transmit Data register.
3. If all bytes of the packet have been written to the Transmit Data register, then
4. If there are more bytes in the packet to be sent, then go to step 2.
While performing steps 1 to 4, the processor should monitor for interrupts
generated by the TDPR. When an interrupt is detected, the TDPR Interrupt
Routine detailed in the following text should be followed immediately.
The TDPR will force transmission of the packet information when the FIFO depth
exceeds the threshold programmed with the UTHR[6:0] bits in the TDPR Upper
Transmit Threshold register. Unless an error condition occurs, transmission will
not stop until the last byte of all complete packets is transmitted and the FIFO
depth is at or below the threshold limit. The user should watch the FULLI and
LFILLI interrupts to prevent overruns and underruns.
TDPR Interrupt Routine:
Upon assertion of INTB, the source of the interrupt must first be identified by
reading the TECT3 Master Interrupt Source register (0020H) followed by reading
one of the second level master interrupt source registers T1E1INT1, T1E1INT2,
T1E1INT3, T1E1INT4 or DS3INT. Once the source of the interrupt has been
identified as the TDPR in use, then the following procedure should be carried
out:
1. Read the TDPR Interrupt Status register.
2. If UDRI=1, then the FIFO has underrun and the last packet transmitted has
transmitted, then go to step 2.
set the EOM bit in the TDPR Configuration register to logic 1. Go to step 1.
been corrupted and needs to be retransmitted. When the UDRI bit transitions
to logic 1, one Abort sequence and continuous flags will be transmitted. The
TDPR FIFO is held in reset state. To re-enable the TDPR FIFO and to clear
the underrun, the TDPR Interrupt Status/UDR Clear register should be written
with any value.
ISSUE 1
142
HIGH DENSITY T1/E1 FRAMER
AND M13 MULTIPLEXER
PM4328 TECT3
Related parts for PM4328-PI
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
High density T1/E1 framer with intefrated M13 multiplexer
Manufacturer:
PMC-Sierra, Inc.
Part Number:
Description:
2 Megabit (256K x 8) 5.0 Volt-only CMOS Flash Memory
Manufacturer:
PMC-Sierra, Inc.
Part Number:
Description:
Interface, Multi-rate Telecom Backplane SERDES for 2.5Gbit/s Interconnect
Manufacturer:
PMC-Sierra, Inc.
Part Number:
Description:
processor, Spectra-9953 Device Driver
Manufacturer:
PMC-Sierra, Inc.
Part Number:
Description:
Ethernet, 8 Channel 10/100 Ethernet over SONET/SDH Mapping Device
Manufacturer:
PMC-Sierra, Inc.
Part Number:
Description:
Interface, Single Chip ADM for 622 & 155Mbit/s
Manufacturer:
PMC-Sierra, Inc.
Part Number:
Description:
Interface, Single Chip ADM for 622 & 155Mbit/s
Manufacturer:
PMC-Sierra, Inc.
Part Number:
Description:
Interface, Multi-rate SATURN User Network Interface for 2x622 and 4x155
Manufacturer:
PMC-Sierra, Inc.
Part Number:
Description:
SONET/SDH TRIBUTARY UNIT PAYLOAD PROCESSOR
Manufacturer:
PMC-Sierra, Inc.
Datasheet:
Part Number:
Description:
Processor, SONET/SDH Tributary Unit Payload Processor for 2488.32Mbit/s
Manufacturer:
PMC-Sierra, Inc.
Part Number:
Description:
HIGH DENSITY 84/63 CHANNEL VT/TU MAPPER AND M13 MULTIPLEXER
Manufacturer:
PMC-Sierra, Inc.
Datasheet:
Part Number:
Description:
SONET/SDH, Single Chip 96 Port SONET/SDH Cross-Connect Switch Element
Manufacturer:
PMC-Sierra, Inc.
Part Number:
Description:
ATM, Sixteen Channel ATM PHY Interface for 155.52 Mbps
Manufacturer:
PMC-Sierra, Inc.
Part Number:
Description:
ATM UNI, Single Channel ATM PHY Interface for 2488.32Mbps
Manufacturer:
PMC-Sierra, Inc.
Datasheet:
Part Number:
Description:
Interface, 4-Channel ATM and Bit HDLC User Network Interface
Manufacturer:
PMC-Sierra, Inc.