PM4328-PI PMC-Sierra, Inc., PM4328-PI Datasheet - Page 98

• Manufacturer Part Number: PM4328-PI
• Description: Framer, T1|E1|T3 Standard Format, 324-BGA
• Manufacturer: PMC-Sierra, Inc.

STANDARD PRODUCT
DATASHEET
PMC-2011596
9.28 Egress System Interface (ESIF)
PROPRIETARY AND CONFIDENTIAL
ANSI T1.107 Section 7.2.1.1 and TR-TSY-000009 Section 3.7, the loopback
command is identified as C3 being the inverse of C1 and C2. Because TR-TSY-
000233 Section 5.3.14.1 recommends compatibility with non-compliant existing
equipment, the two other loopback command possibilities are also supported. As
per TR-TSY-000009 Section 3.7, the loopback request must be present for five
successive M-frames before declaration of detection. Removal of the loopback
request is declared when it has been absent for five successive M-frames.
DS1 payload loopback can be activated or deactivated under software control.
During payload loopback the DS1 stream being looped back still continues
unaffected in the demultiplex direction. The second and fourth demultiplexed
DS1 streams are logically inverted, and all four demultiplexed DS1 streams can
be replaced with AIS on an individual basis.
Similar functionality supports CCITT Recommendation G.747. The FIFO is still
required for rate adaptation. The frame alignment signal and parity bit are
generated and inserted by the timing circuitry. Software control is provided to
transmit Remote Alarm Indication (RAI), high speed signal AIS, and the reserved
bit. A diagnostic option is provided to invert the transmitted frame alignment
signal and parity bit.
When demultiplexing three 2048 kbit/s streams from a G.747 formatted 6312
kbit/s stream, the MX12 performs bit destuffing via interpretation of the C-bits.
Tributary payload loopback can be activated or deactivated under software
control. Although no remote loopback request has been defined for G.747,
inversion of the third C-bit triggers a loopback request detection indication in
anticipation of Recommendation G.747 refinement. All three demultiplexed 2048
kbit/s streams can be replaced with AIS on an individual basis.
The Egress System Interface (ESIF) block provides system side serial clock and
data access as well as H-MVIP access for up to 28 T1 or 21 E1 transmit
streams. There are several master and slave clocking modes for serial clock and
data system side access to the T1 and E1 streams. When enabled for 8.192Mb/s
H-MVIP there are three separate interfaces for data, CAS signaling and CCS
signaling. The H-MVIP signaling interfaces can be used in combination with the
serial clock and data and SBI interface in certain applications. Control of the
system side interface is global to TECT3 and is selected through the
SYSOPT[2:0] bits in the Global Configuration register at address 0001H. The
system interface options are serial clock and data, H-MVIP, SBI bus, SBI bus
with CAS or CCS H-MVIP and serial clock and data with CCS H-MVIP.
Two Clock Master modes provide a serial clock and data egress interface with
per link clocking provided by TECT3. The clock master modes are Clock Master:
ISSUE 1
85
HIGH DENSITY T1/E1 FRAMER
AND M13 MULTIPLEXER
PM4328 TECT3